Lanzar VBD500 - Manuals - manualsarea.com

Page 2 - INSTALLATION; driving function of the driver.

2 1 INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use...

Page 4 - USING THE DETACHABLE FRONT PANEL; To Detach the Front Panel; Remove the front panel by pulling its middle-hand outward.

4 USING THE DETACHABLE FRONT PANEL To Detach the Front Panel 1. Press the open button (open), then the front panel will be folded down. 2. Remove the front panel by pulling its middle-hand outward. 3. For safekeeping, store the front panel in the supplied protective case immediately after being remo...

Page 5 - in poor electrical contact.

5 To Reinstall the Front Panel 1. Push the front panel into the main body. A ‘click’ sound should be heard. 2. Note that if the front panel fails to lock in position properly, press control button may not function and LCD display may be missing some segments. Pushing the open button and then reinsta...

Page 6 - WIRING CONNECTION

6 WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT RchSPEAKER REAR RchSPEAKER Rch RED Lch WHITE (GREY) RCA CABLE ANTENNA CONNECTOR RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B–) MEMORY BACK-UP IGNITION SWITC...

Page 7 - OPERATION; GENERAL OPERATION; Switch on the unit by pressing any button [except; Press; OPEN

OPERATION GENERAL OPERATION • ON/OFF Switch on the unit by pressing any button [except OPEN button (7) and EJECT button (4)]. When system is on, press PWR button (9) to turn off the unit. • FACEPLATE RELEASE Press OPEN button (7) to detach the removable faceplate. 7 12 3 17 15 19 14 10 13 1 8 2 18 6...

Page 9 - RADIO OPERATION

9 RADIO OPERATION • BAND SELECTION At tuner mode, press LOU/BND button (14) shortly to select the desired band. The reception band will change in the following order: • STATION SELECTION Press MAN/SEK button (17) or MAN/SEK button (18) shortly to activate automatic seek function. Press for several s...

Page 10 - CD OPERATION

CD OPERATION • SELECT TRACKS Press MAN/SEK button (17) or (18) to move to the previous track or the following track. Track number shows on display.Hold MAN/SEK button (17) or (18) to fast reverse or fast forward. CD play starts from when you release the button. • STOP PLAYING Press PAU button (21) t...

Page 11 - CONTROL & FUNCTION KEYS; REMOTE CONTROL HANDSET

11 8 6 2 1 3 4 5 7 14 9 13 11 12 15 10 CONTROL & FUNCTION KEYS 1. POWER = Power ON/OFF Button 2. MOD = Mode Button 3. S (SEL) = Select Button 4. DSP = Display Button 5. BND = Band Select Button 6. AMS = Automatically Memory Storing & Program Scanning Button 7. VOL + = Volume Up Button 8. VOL...

Page 12 - SPECIFICATION; GENERAL; FM

12 SPECIFICATION GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 163 (D) x 50 (H) Tone Controls- Bass (at 100 Hz) : +10 dB / –10 dB - Treble (at 10 KHz) : +10 dB / –10 dB Maximum Output P ower : 50W x 4 (ch) Current Drain : 15 Ampere CD PLAYER Signal ...

Page 13 - TROUBLE SHOOTING; Symptom

TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition is not on. If the power supply is properlyconnected to the car accessory...