Lanzar OPTIX-10OPTIX-10 - Manuals

Page 3 - t a b l e o f c o n t e n t s

general features precautions features and specifications system wiring mounting and installation noise check and system adjustment troubleshooting 2 3 4-6 7-11 12-13 14 15 t a b l e o f c o n t e n t s

Page 4 - g e n e r a l f e a t u r e s

10 Crossover Channels Blue Light Illumination 4 Channel Inputs Signal Pass-through for Additional Processors Remote Bass Level Control High Channels: Separate Front and Rear Frequency and Gain Controls Mid Channels: Separate Front and Rear Frequency and Gain Controls Sub Channels: Frequency and Gain...

Page 5 - P r e c a u t i o n s

3 P r e c a u t i o n s To prevent short circuits, be sure to disconnect the negative battery ground lead before wiring the system up. When you finish the installation, be sure to make one more check to be sure everything is done correctly. Reinstate all car parts that were removed. Reconnect the ne...

Page 6 - f e a t u r e s a n d s p e c i f i c a t i o n s

4 f e a t u r e s a n d s p e c i f i c a t i o n s

Page 9 - S y s t e m w i r i n g

7 S y s t e m w i r i n g 2-CHANNEL 3 WAY SYSTEM REAR CHANNEL Speakers FRONT CHANNEL Speakers Head unit (Stereo, DVD Player, Tape Deck, etc.) TO REAR OUTPUT TO SUB OUTPUT toREMOTEOUTPUTfromHEADUNIT BATTERY GROUND TO LINE OUT OF HEAD UNIT TO FRONT OUTPUT SUB CHANNEL Speakers

Page 14 - M o u n t i n g a n d i n s t a l l a t i o n

12 M o u n t i n g a n d i n s t a l l a t i o n Your new Opti Series crossover comes complete with all required mounting hardware. Please read the Installation Precautions section below before installing your Lanzar Opti signal processor, and then refer to the diagrams provided to connect power,aud...

Page 16 - N o i s e c h e c k a n d s y s t e m a d j u s t m e n t

NOISE CHECK Check the entire audio system for noise before permanently securing the CROSSOVER mounting 1. Start the engine.2. Turn the audio system on.3. Rev the engine and vary the VOLUME of the audio system to determine if there is any unwanted noise. If so, turn both the audio system and the engi...

Page 17 - T B O U B L E S H O O T I N G G U I D E

1. There is an audible distortion at a low volume level. PROBLEM POSSIBLE CAUSE • Output levels NOT set correctly.• Crossover frequencies NOT set correctly.• Check for shorts on the speaker leads. 2. A whining sound can be heard through the speakers when the audio system is at lowvolume with the eng...

Page 18 - l i m i t e d w a r r a n t y p o l i c y; C r o s s o v e r

All Lanzar Signal Processors are carefully constructed and thoroughly testedbefore shipment. Units purchased in the USA are warranted to be free of defectsin material and workmanship for three (3) years from the date of purchase. Thiswarranty is limited to the original retail purchaser of the Signal...