Lanzar 15 - Manuals - manualsarea.com

Page 3 - t a b l e o f c o n t e n t s

general features precautions features and specifications system wiring mounting and installation noise check and system adjustment troubleshooting 2 3 4-5 6-9 10-11 12 13 t a b l e o f c o n t e n t s

Page 4 - g e n e r a l f e a t u r e s

15 Band Equalizer Controls per Channel in 1/2 and Full Octave Steps Blue Light Illumination ± 12 dB Boost/Cut at Each Frequency Setting Front, Rear and Line Outputs Separate Front, Rear and Line Output Level Controls Front/Rear Fader Control Power LED Indicator EQ Bypass Switch Gold-Plated Connector...

Page 5 - P r e c a u t i o n s; Reinstate all car parts that were removed.

3 P r e c a u t i o n s To prevent short circuits, be sure to disconnect the negative battery ground lead before wiring the system up. When you finish the installation, be sure to make one more check to be sure everything is done correctly. Reinstate all car parts that were removed. Reconnect the ne...

Page 6 - f e a t u r e s a n d s p e c i f i c a t i o n s

4 f e a t u r e s a n d s p e c i f i c a t i o n s

Page 8 - S y s t e m w i r i n g

6 S y s t e m w i r i n g Standard 4-Channel Output For standard 4-channel operation, plug both the left and right RCAoutputs from your head unit into the E-15 inputs. The output powercan be distributed to either the front or rear speakers by using thefader control. With the fader is in the center d...

Page 12 - M o u n t i n g a n d i n s t a l l a t i o n

10 M o u n t i n g a n d i n s t a l l a t i o n Your new Opti Series Octave Equalizer comes complete with all required mounting hardware. Please read the Installation Precautions section below before installing your Lanzar Opti signal processor, and then refer to the diagrams provided to connect po...

Page 14 - N o i s e c h e c k a n d s y s t e m a d j u s t m e n t

NOISE CHECK Check the entire audio system for noise before permanently securing the EQUALIZER mounting 1. Start the engine.2. Turn the audio system on.3. Rev the engine and vary the VOLUME of the audio system to determine if there is any unwanted noise. If so, turn both the audio system and the engi...

Page 15 - PROBLEM; POSSIBLE CAUSE; T B O U B L E S H O O T I N G G U I D E

1. There is an audible distortion at a low volume level. PROBLEM POSSIBLE CAUSE • Output levels NOT set correctly.• EQUALIZER frequencies NOT set correctly.• Check for shorts on the speaker leads. 2. A whining sound can be heard through the speakers when the audio system is at lowvolume with the eng...

Page 16 - l i m i t e d w a r r a n t y p o l i c y; E q u a l i z e r

All Lanzar Signal Processors are carefully constructed and thoroughly testedbefore shipment. Units purchased in the USA are warranted to be free of defectsin material and workmanship for three (3) years from the date of purchase. Thiswarranty is limited to the original retail purchaser of the Signal...