Lantronix TS-DDH - Manuals

Ethernet to Serial Converter 3 Continue by turning to the following topics: 1. Install the Ethernet Device Installer 2. Run the Ethernet Device Installer Computer Setup Install and run The Ethernet Redirector Maintenance The ESC should never need any maintenance. If a problem does develop, pulling o...

4 Ethernet Device Installer Fig. 1 To use the ESC Ethernet-to-Serial Converter, some software on the accompanying CD (CD-UDS-04A) must first be installed and run on your computer. The ESC comes with a Quick Start Guide from Lantronix (Fig. 1) and a CD (Fig. 2). Everything you need to know about the ...

Data Downloading Hardware 6 Fig. 7 7. Click Close. Run Ethernet Device Installer

7 Run Ethernet Device Installer Assign the IP Address and Network Class. 1. Click the START button on the task bar and select All Programs > Lantronix > DeviceInstaller > DeviceInstaller (Fig. 1). Fig. 1 The DeviceInstaller 3.6 window (Fig. 2) will appear. Fig. 2 2. Click Search. DeviceInst...

Run Ethernet Device Installer 9 Fig. 6 6. Click Assign. The new address will be saved, and the Ethernet adaptor will be rebooted (Fig. 7). Fig. 7 7. Click Finish. Configure the Ethernet Adaptor. 1. Click the START button on the task bar and select All Programs > Lantronix > DeviceInstaller >...

Data Downloading Hardware 12 Fig. 14 7. Click Apply. The program should now update the settings and reboot the device. When in use, both ports should have a baud rate matching the controller baud setting, 115200. (The factory default is 9600.) Also be sure that Data bits = 8, Parity = None, Stop bit...

13 The Ethernet Redirector Install the Redirector from the CD. 1. Choose the destination folder (Fig. 1) for the Redirector. Fig. 1 2. Click Next. Fig. 2 3. Click Next.

Data Downloading Hardware 14 Fig. 3 4. Click Finish to complete the install. Launch the Redirector. Fig. 4 1. Open the Com Port Redirector and set up the virtual com ports. 2. Click the Com Setup button (Fig. 4). 3. Check the box next to the first two Com labels. This is usually Com3 and Com4, so th...

16 ESC Troubleshooting Follow these steps in case of a communications failure: 1. Confirm hardware connections 2. Confirm software settings 3. Contact TigerStop Customer Support Confirm Hardware Connections The first step in troubleshooting almost any type of technical failure is to check the physic...

17 SX Serial Extender Description and Use The Serial Extender allows your computer to communicate with your Level 2 (or higher) TigerStop when the total cable distance is up to 1000 feet (Fig. 1). You should use an SX when your TigerStop is separated from your computer by at least 75 feet. A CAT-5 c...