Kohler K-12105-H - Manuals - manualsarea.com

Page 2 - BA; IMPORTANT SAFETY INSTRUCTIONS; SHOCK, OR INJURY TO PERSONS; READ AND FOLLOW ALL INSTRUCTIONS

Kohler Co., Kohler, WI 115982-2- BA (-) 2 IMPORTANT SAFETY INSTRUCTIONS ATTENTION INSTALLER: INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS WARNING: When using this unit, always follow basic precautions, includin...

Page 3 - TABLE OF CONTENTS

3 115982-2- BA (-) Kohler Co., Kohler, WI TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 2 . . . . . . . . INTRODUCTION 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ROUGHING-IN: K-12105-H*, K-12106-H* 4 . . . . . . . Ordering Information 4 . . . . . . . . . . . . . . . . . . . . . . ...

Page 5 - PRODUCT REQUIREMENTS

5 115982-2- BA (-) Kohler Co., Kohler, WI 2. PRODUCT NOTICES A. INSTALLER HAZARD NOTIFICATION DANGER: Risk of fire, electric shock, or injuryto persons. Read important safety instructions oninside front cover of these instructions. WARNING: Risk of electrical shock. A licensedelectrician should make...

Page 6 - INSTALLATION REQUIREMENTS

6 115982-2- BA (-) Kohler Co., Kohler, WI E. ELECTRICAL REQUIREMENTS The installation must have a Class A Ground-FaultCircuit-Interrupter (GFCI). The GFCI protects againstline-to-ground shock hazard. Use a 120 V, 20 A, 60 Hzdedicated service for the whirlpool. 4. INSTALLATION REQUIREMENTS A. TOOLS R...

Page 7 - SITE REQUIREMENTS; B. SUBFLOOR PREPARATION

7 115982-2- BA (-) Kohler Co., Kohler, WI 5. SITE REQUIREMENTS A. OLD BATH REMOVAL Disconnect the drain at the trap. Remove the old wallmaterial. Slip boards under the old bath feet toprotect the floor and slide the old bath out of the recessas illustrated. FloorProtectionBoards Old Bath B. SUBFLOOR...

Page 9 - BEFORE INSTALLING UNIT; A. PARTIALLY INSTALL BATH DRAIN

9 115982-2- BA (-) Kohler Co., Kohler, WI F. STUD POCKET PREPARATION Construct a minimum 2x4 recess designed for yourparticular installation. Make sure you allow for access tothe pump in the event the unit requires service. Whenconstructing the framing, allow for the thickness of suband finish wall ...

Page 10 - INSTALL THE WHIRLPOOL

10 115982-2- BA (-) Kohler Co., Kohler, WI 7. INSTALL THE WHIRLPOOL A. WHIRLPOOL SET-IN 1. Lay out and mark the supply or mixing valve holelocations on the back of the unit. Drill a 1/4”diameter pilot hole at each fitting mark. 2. For multiple-unit installations, where the supplyfittings have been a...

Page 12 - ELECTRICAL CONNECTIONS; A. IDENTIFY ELECTRICAL REQUIREMENTS; WATER TEST WHIRLPOOL AND ELECTRONICS

12 115982-2- BA (-) Kohler Co., Kohler, WI 8. ELECTRICAL CONNECTIONS A. IDENTIFY ELECTRICAL REQUIREMENTS The model number is printed on a label at the pump endof the whirlpool. The label identifies electrical rating. B. WIRING INFORMATION – 120 V, 60 HZ – 2-SPEED PUMP (UL LISTED) MODELS WARNING: Ris...

Page 13 - COMPLETE FINISH WALL; COMPLETE INSTALLATION; A. INSTALL WHIRLPOOL TRIM KIT

13 115982-2- BA (-) Kohler Co., Kohler, WI 10. COMPLETE FINISH WALL Install water-resistant wall material for either flush oralcove installation as follows: For flush installations: Install water-resistant wallmaterial to within 1/4” of the module edge. Install desiredtrim around the unit to conceal...

Page 14 - CONFIRM PROPER OPERATION

14 115982-2- BA (-) Kohler Co., Kohler, WI D. INSTALL SHOWER ROD The shower rod, if used, should now be installed.Position the shower rod so the shower curtain hangsinside the bath. E. SHOWER DOOR INSTALLATION Shower doors for this unit are available from the KohlerCo. Contact your dealer for more i...

Page 15 - TROUBLESHOOTING PROCEDURES; A. FLEXJET INSTALLATION

15 115982-2- BA (-) Kohler Co., Kohler, WI B. OPERATING SEQUENCE Refer to the chart at right for the proper operatingsequence. 1. Turn on the whirlpool jets. Adjust each jet foroptimum air/water mixture. 2. A built-in timer automatically stops the motor afterapproximately 20 minutes of operation. 3....