KitchenAid KHDP138510 - Manuals

Page 4 - Standard burners; Using the burners; To turn on one of the burners:

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 4 Product description and symbols 1. Removable pan stand grids 2. WOK burner 3. WOK burner control knob Control Symbols Standard burners Professional burner Off Maximum flame Minimum flame Off Maximum flame outer ring/maximum flame inner ring Minim...

Page 5 - Practical advice on using the hob; Read the instructions to get the best out of your; Positioning the pan supports and wok support (also as spacer)

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 5 Practical advice on using the hob Read the instructions to get the best out of your hob. - Use pans with a similar diameter to the burner (see the table on this page) - Use flat bottomed pans except with the wok support. - Do not use excessive wa...

Page 7 - Gas Consumption and Injectors table; Wok; Warnings and Suggestions; These instructions are only valid in

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 7 Gas Consumption and Injectors table Model KHDP1 38510 Gas Type Natural @ 1.00 kPa (test point pressure) Universal LP @ 2.75 kPa (inlet pressure) Burner Nominal Gas Consumption (MJ/h) Nominal Injector Size (mm) Nominal Gas Consumption (MJ/h) Nomin...

Page 8 - Safeguarding the Environment

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 8 • In the event of prolonged usage, additional ventilation may be required (opening a window or increasing the extraction speed of the hood). Warning • Keep children away from the hob when in use and don't let them play with the control knobs or a...

Page 9 - Installation; IMPORTANT: if flexible hose is used, it must be

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 9 Installation THIS OPERATION MUST BE PERFROMED BY QUALIFIED TECHNICIAN OR AUTHORISED PERSON. Technical information for the installer • This appliance can be built into a 30mm to 70mm thick worktop. • If no oven is to be installed below the hob, a ...

Page 10 - Gas connection

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 10 Gas connection WARNING! This operation must be performed by a qualified technician. • Before Installation make sure that local gas delivery conditions (nature and pressure) are compatible with the setting of the hob (see the gas consumption and ...

Page 11 - Electrical Connection; The electrical connections must comply with current local; The appliance must be earthed.

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 11 • In some cases burner will fail to ignite immediately and will seem to blow’s lightly when do ignite, this is usually due to the air in the gas pipe which should clear itself within seconds of operation. If after following instructions given, s...

Page 12 - Use pressure regulators suitable for the gas

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 12 Installation The cook top is designed to be built in to a work surface as shown in the figure. Before installing the cook top, install the gasket seal “X” around the entire perimeter of the hole where it will be inserted. The dimensions of the h...

Page 13 - Replacing the injectors; Injectors replacement in the wok burner; Regulating the minimum flow level of the gas taps; WARNING: DO NOT MODIFY THIS APPLIANCE

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 13 Replacing the injectors Note: Refer to the injector table earlier in the manual to ensure the correct type of injector is to be fitted. Note: Before installing the hob, please remember to stick the gas calibration label, provided with the replac...

Page 14 - Care and Maintenance; Before any cleaning and/or maintenance; Care and maintenance of the gas burners; Note: Hobs fitted with electronic ignition and

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 14 Care and Maintenance Before any cleaning and/or maintenance operation, disconnect the hob from power supply and wait until it is cold. To keep the hob in perfect condition, remove any food residuals and clean it after every use. Hob cleaning: - ...

Page 15 - Troubleshooting guide; The burner does not ignite, or the flame is; After Sales Service; Before contacting our Customer Care Centre please check

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 15 Troubleshooting guide If the hob is not working properly work through this guide before contacting our Customer Care Centre. The burner does not ignite, or the flame is unsteady? Check that: 1. the gas, or electricity supply has not been interru...

KitchenAid KHDP138510 - Manuals

Manuals:

User Manual KitchenAid KHDP138510

Summary

KitchenAid Hobs Manuals