KitchenAid KHDD238510 - Manuals

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 11 • In some cases burner will fail to ignite immediately and will seem to blow’s lightly when do ignite, this is usually due to the air in the gas pipe which should clear itself within seconds of operation. If after following instructions given, s...

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 12 Installation The cook top is designed to be built in to a work surface as shown in the figure. Before installing the cook top, install the gasket seal “X” around the entire perimeter of the hole where it will be inserted. The dimensions of the h...

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 13 Replacing the injectors Note: Refer to the injector table earlier in the manual to ensure the correct type of injector is to be fitted. Traditional burners (T) 1. Remove the cap (A). 2. Remove the spreader (B). 3. Unscrew the injector (C) with a...

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 14 Care and Maintenance Before any cleaning and/or maintenance operation, disconnect the hob from power supply and wait until it is cold. To keep the hob in perfect condition, remove any food residuals and clean it after every use. Hob cleaning: - ...

www.kitchenaid.com.au | www.kitchenaid.co.nz Page | 15 Troubleshooting guide If the hob is not working properly work through this guide before contacting our Customer Care Centre. The burner does not ignite, or the flame is unsteady? Check that: 1. the gas, or electricity supply has not been interru...