KitchenAid 9871915A - Manuals

5 Cutout Dimensions Clearance Dimensions Electrical Requirements Recommended Grounding Method This compactor is for use on a single phase, 115-volt, 60 Hz, AC only 15- or 20-amp fused and properly grounded circuit and is equipped with a grounding plug as shown below. It is recommended that a separat...

7 Adjusting the Toe Plate If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows: 1. Mark on each side of the toe plate the amount of toe plate that rubs the floor covering. 2. Remove the drawer from the unit. (See Step 3 in the “Unpacking” section.) 3. Use a rul...

9 3. Push Side-Lock Latch down and tilt drawer side open. 4. Lift out bag. Installing a New Bag Do not use any kind of bag other than those designed especially for use in your compactor. Order replacement compactor bags through your local dealer or by calling the toll-free number on the cover or in ...

10 3. Hold the lever-action lock down and tilt the side of the drawer out until the lock clears the drawer front. NOTE: If desired, the drawer side can be removed by tilting it up, then lifting it out. 4. Wash the interior of the drawer with a clean sponge or soft cloth and a mild detergent in warm ...

11 The drawer won’t open ■ Is the ram all the way up? Drawer will open only when ram is fully raised. To raise the ram on models with a Key-Knob (or Key-Switch): Turn the Key-Knob (Key-Switch) to START and release. See “Starting Your Compactor.” To raise the ram on models with push button controls:P...