Kettler Bicycle - Manuals

5 Charging the Battery Before using it for the first time, the battery must be charged for at least four hours. When deli-vered, the battery is in the uncharged state and is in sleeping mode.The battery can be charged in any state i.e. at any charge level. Removing the battery To charge the battery,...

6 Note: 1. The length of the charging process depends on the capacity and the level of the charge. 2. Charge the battery at room temperature only. As soon as the ambient temperature of the battery is less than 0° or more than 40° the battery cannot be charged and the charging unit remains in standby...

7 Operation and Control Operating Unit The operating unit is for switching the system on and off, selecting the desired assistance leveland displaying the amount of charge remaining in the battery. Switching on Press the Power button on the operating unit on your handlebars.All the LEDs light up for...

8 Assistance Mode, Range Selecting degree of assistance With the Mode button on the operating unit you can select one of three different assistance modes at any time.Press the Mode button until you arrive at the mode you require. The best amount of assistance and the consequent range of the battery ...

9 Motor Bottom-bracket motorBrushless DC motorPower output: 250 WWeight: approx. 3.5 kgControl by means of frictionless magnetic torque sensor Overload When the motor is overloaded, the LEDs on the operating unit flash in the following pattern Overheating When the motor is overheated, the LEDs on th...

10 Technical Data Battery Battery power: 260 Wh, 26 V 10 Ah, removable and rechargeable Type: Panasonic lithium, ions, manganese Model: Li-ion battery Ni-Li NKY224B01 10 Ah Charging time: approx. 3 h., initial charge 4 h. Weight: 2.4 kg Accumulator status At the side of the battery there is a displa...

11 Technical Data Battery Sleeping Mode In its original state and at the first start-up the battery is in sleeping mode. For this reason the battery has to be fully charged before it is usedfor the first time.If the charge level drops below 50% and it is not charged for more than two weeks, it goes ...

12 Technical Data Charging Unit The charging unit type NKJ38 is supplied with the cycle. Weight of charging unit: 530 g Power supply: 220 V (50 Hz) AC Power: 62 W A charging unit is supplied with the cycle. To charge it, take the unit out of the box and remove the plastic foil. Failure to remove the...

13 Care and Maintenance Inspection Follow the instructions in the enclosed KETTLER Instructions for Assembly and Operation Tyre Pressure The tyre pressure has an important influence on the performance of the Pedelec. To ensure that the range of the battery is not affected, ensurethat the tyre pressu...

14 Troubleshooting Do not attempt to repair the electric drive system, control system or battery. For any necessary service or repair work, always contact yourKETTLER dealer who has the necessary information and expertise to carry out repairs. Reset: Errors in the sensor torque measurement In case o...

15 Guarantee / General Notes Battery Batteries are subject to wear and tear. It is therefore normal for the capacity of the battery to decline with increasing age, use, and frequency ofcharging.For other guarantee provisions, please refer to the KETTLER Instructions for Assembly and Operation. Groun...