Kenmore Ventilation Hood 31133- Manuals

Page 2 - WARNING; CAUTION; READ AND SAVE THESE INSTRUCTIONS; SAFETY INSTRUCTIONS; INTENDED FOR DOMESTIC COOKING ONLY

2 WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address listed in the warranty. 2. Before servicing or cleaning unit, switch pow...

Page 3 - arranty; CLEANING

3 OPERATION OPERATION W arranty Saf ety Cleaning Operation Installation Ser vice P a rt s Always turn ON your hood before you begin cooking in order to establish an air fl ow in the kitchen. Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the w...

Page 4 - PARTS NOT INCLUDED WITH HOOD; PARTS INCLUDED WITH HOOD

4 PARTS INCLUDED WITH HOOD TOOLS NEEDED FOR HOOD INSTALLATION Aluminum grease fi lters (2 per hood) Parts Bag including: 5 no. 8 x 1½” countersunk screws 8 no. 8 x 3/4” screws 6 no. 8 x 3/8” screws 6 Drywall anchors 3 Washers Screwdriver (Robertson or Phillips) Pencil Tape Measure Drill Sabre Saw Ke...

Page 5 - RANGE HOOD SYSTEM; Installation

5 HL0142 RANGE HOOD SYSTEM Wall & Roof Caps Broan Model 643 8” Round Wall Cap Broan Model 634 or 644 Roof Cap 8” Round Adjustable Elbow 8” Round Standard Duct 31130 or 31133 Range Hood Elbow Ductwork W arranty Saf ety Cleaning Operation Ser vice P a rt s Installation Broan Model 639 3¼” x 10” St...

Page 6 - EQUIVALENT DUCT LENGTH CHART; Straight Duct

6 EQUIVALENT DUCT LENGTH CHART HR0049 HR0048 HR0047 Straight Duct 8-in. round x 2-ft. long Equivalent length 2 ft. Broan Model 643 8-in. Round Wall Cap Equivalent length 30 ft. (15-ft. w/o damper) Broan Model 634 or 644 8-in. Round Roof Cap Equivalent length 30 ft. (7-ft. w/o damper) Kenmore range h...

Page 7 - SELECT INSTALLATION TYPE; OR

7 1. Plan where and how the ductwork will be installed. Install proper-sized ductwork, transition(s), elbow(s), and roof or wall cap. For best results, use a minimum number of transition and elbows. 2. The minimum hood distance above cooktop must not be less than 24’’. A maximum of 30’’ above cookto...

Page 8 - WIRING INSTALLATION; The BLUE wires are for a make-up

8 WARNING: Improper grounding can result in a risk of electric shock. Consult a qualifi ed electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded. Do not use an extension cord. If the power supply cord is too short...

Page 9 - PREPARE THE HOOD

9 2. Choose the opening: HO0142 V ERTICAL DISCHARGE : Using a Robertson or a Phillips no. 2 screwdriver, remove the 4 top metal plate retaining screws in order to clear the vertical discharge opening (see illustration beside). Discard the metal plate and its screws. H ORIZONTAL DISCHARGE : In order ...

Page 11 - INSTALL THE HOOD

11 INSTALL THE HOOD 1. Construct wood wall framing that is fl ush with surface of wall studs. Wood wall framing must be at least 1/2” thick and 3” high. Ensure to assemble wood wall framing to wall studs for a solid installation. Ensure the height of the framing will allow the mounting bracket to be...

Page 13 - INSTALLING GREASE FILTERS; FINALIZE THE INSTALLATION; Refer to page 4 for ordering information.; CHANGING LIGHT BULBS

13 INSTALLING GREASE FILTERS Rest rear fi lters edge on fi lter springs ( A ) in the range hood. Using metal latch tab, tilt up the fi lters into position. Make sure fi lter tabs ( B ) are securely engaged in range hood front edge after installation. HD0393 A B HO0140 U PPER FLUE MOUNTING BRACKET F ...

Page 14 - SERVICE PARTS

SERVICE PARTS K EY NO . P ART NO . D ESCRIPTION Q TY . ( HOOD WIDTH ) 30” 36” 1 18504 U PPER FLUE MOUNTING BRACKET 1 1 2 18494 U PPER DECORATIVE FLUE 1 1 3 18496 L OWER DECORATIVE FLUE 1 1 4 18515 C OVER PLATE FOR 8” ROUND TOP EXHAUST 1 1 5 18522 E LECTRONIC CONTROL MODULE ( INCLUDING O VERLAY , ITE...