Kenmore Ultra High-Efficiency Water Softener- Manuals

6 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Packing List The parts required to assemble and install the water softener are included with the unit. Thoroughly check the water softener for possible shipping damage and parts loss. Also inspect and note any dama...

7 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Plan Your Installation TYPICAL INSTALLATION 5. Do not install in a place where the softener could freeze. Damage caused by freezing voids the war- ranty by Sears Brands Management Corporation. 6. Put the softener i...

8 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Plan Your Installation psi, buy and install a pressure reducing valve in the pipe supplying water to the softener’s inlet. NOTE: If water pressure during the day is 100 psi or more, pressure during the night may go...

9 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Installation INSTALL SINGLE BYPASS VALVE (cont.) Before installing the bypass valve and/or installation adaptors, make sure that the turbine and support are firmly in place inside the softener valve’s outlet port. ...

10 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Installation CONNECT THE VALVE DRAIN HOSE Take a length of 3/8” inside diameter drain tubing (supplied) and attach one end to the drain fitting (see Fig. 11). Use a tube clamp from the parts bag to hold it in plac...

11 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Installation Figure 13 3-VALVE BYPASS Bypass Valve Inlet Valve Outlet Valve FOR SERVICE Close bypass valve. Open inlet & outlet valves. FOR BYPASS Open bypass valve. Close inlet & outlet valves. LEAK TEST ...

13 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Programming the Softener Select press for tonight hold for immediate Salt Set Level Low Salt Use Water Figure 15 LOW SALT indicator SET SALT LEVEL button DOWN button WATER USE button Display UP button REGENERATION...

14 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com 1 . Press the r UP or s DOWN buttons to set the hardness of your water supply, in grains per gallon. The default is 25. NOTE: If your water supply contains iron , compensate for it by adding to the water hardness ...

15 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Sanitizing the Softener SANITIZE THE WATER SOFTENER 1. Open salt lid, remove the brinewell cover and pour about 3 oz. (6 tablespoons) of household bleach into the softener brinewell. Replace the brinewell cover. 2...

16 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Controller Features Figure 22 Figure 23 Figure 25 LEVEL SALT press for tonight hold for immediate Salt Set Level Figure 24 Salt Level Decal Salt Level Bars Brinewell EXTRA RECHARGE Sometimes, a manually initiated ...

19 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Figure 35 Controller Features 8. Press SELECT again to display the alternating screens shown in Figure 33. BACKWASH & FAST RINSE TIMES: If you experience salty tasting water after regeneration, you may need to...

21 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Care of Your Water Softener SALT BRIDGE Sometimes, a hard crust or salt “bridge” forms in the brine tank. It is usually caused by high humidity or the wrong kind of salt. When the salt “bridges,” an empty space fo...

22 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Service Information TROUBLESHOOTING If your water softener does not work properly, make the following easy checks. Often, you will find what is wrong yourself and you won’t have to call and wait for service. If yo...

23 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Figure 41 Figure 42 Service Information 1. To enter diagnostics, press the SELECT button and hold for three seconds. The display will change to show turbine count, valve cycle position, and position switch status ...

24 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com MANUAL ADVANCE REGENERATION CHECK This check verifies proper operation of the valve motor, brine tank fill, brine draw, regeneration flow rates, and other controller functions. Always make the initial checks first...

24 VAC Transformer Turbine Sensor OUT GND +5 Position Switch NO NC grn brn Valve Motor Back of Controller (PWA) AC INPUT POS. / TURBINE MOTOR Figure 46 WIRING SCHEMATIC 25 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Service Information

26 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Water Softener Exploded View Kenmore Model No. 625.384200 Valve Assembly See Pages 28 & 29 for parts 1 2 3 4 5 6 7 8 25 Rating Decal Location 9 11 10 12 13 14 15 16 24 18 17 19 20 26 27 28 31 22 21 23 30 29

27 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Softener Parts List Key No. Part No. Description 1 7325435 Top Cover 2 7325451 Salt Lid (order decal & badge below) ¢ 7325469 Instruction Decal 3 7325477 Kenmore Badge 4 7275907 Transformer, 24V, 10VA 5 732783...

28 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Valve Assembly Exploded View 50 51 53 52 54 55 56 58 57 59 60 69 61 62 67 68 63 64 65 74 75 70 71 72 77 78 73 Seal Wear Strip Cross-Section View 76 66 79 80 82 81 83 84 85 86 87 88 89 90 91 92 93 94 95 96

29 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Valve Parts List Key No. Part No. Description 50 7224087 Screw, #8-32 x 1” (2 req.) 51 7286039 Motor (incl. 2 ea. of Key No. 50) 52 7231393 Motor Plate 53 0900857 Screw, #6-20 x 3/8” (2 req.) 54 7171250 Bearing 55...

30 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com Notes

FOR IOWA USE ONLY All sales in Iowa require the following signature before consummation of sale. These signatures must be retained by seller/renter for 2 years minimum.Buyer/Renter __________________________________________________________ Date _________________Seller _______________________________...

For repair – in your home – of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner’s manuals that you need to do-it-yourself. For Sears professional installation of home ...