John Lewis JLDWS1208 - Manuals

The control panel D E 1. Digital display2. Delay start button3. Programme selection buttons4. Indicator lights5. On/Off button6. Function buttons Indicator lights In addition to the programme indicator lightsthat allow you to see which programme isrunning or has been selected, other indicatorlights ...

The digital display The digital display indicates:• The level of hardness to which the water softener is set, • The approximate remaining time of the running programme, • Activation/deactivation of the rinse aid dispenser ( ONLY with Multi tab function active), • The end of a washing programme (the ...

3. Press function button C , the lights of function buttons A and B go off while the light of function button C continues to flash. The digital display shows the currentsetting. Audible signals deactivated Audible signals activated 4. To change the setting, press again function button C . Each time ...

Consumption values 1) Programme Programme duration (in minutes) 2) Energy consumption (in kWh) Water consumption (in litres) 70° Intensive - 1,4 - 1,6 16 - 18 Automatic - 1,1 - 1,7 12 - 23 50° Economy 3) - 1,0 - 1,1 12 - 13 Quick wash - 0,9 9 Rinse hold - 0,1 4 1) The consumption values are intended...

Examples: displayed, 5 intermittent audible signals, pause, etc. = level 5 displayed, 10 intermittent audible signals, pause, etc. = level 10 4. To change the level, press function button A . Each time the button is pressed the level changes. (For the selection of thenew level see the chart). Exampl...

Daily use • Check if it's necessary to refill with dishwasher salt or rinse aid. • Open the door and slide out the baskets to load the dishes. • Load cutlery and dishes into the dishwasher. • Fill with dishwasher detergent.• Select a wash programme suitable for the cutlery and dishes. • Start the wa...

If the handles protrude from the bottom ofthe basket, obstructing the lower spray arm,load the cutlery with the handles facingupwards. Mix spoons with other cutlery toprevent them from sticking together.For best results we recommend you use thecutlery grids. If the size and dimensions of thecutlery ...

Warning! After loading your machine always close the door, as anopen door can be a hazard. Use of detergent Only use detergents specificallydesigned for use in dishwashers.Please observe the manufacturer’sdosing and storage recommendationsas stated on the detergent packaging. Using no more than the ...

Detergent tablets Detergent tablets from differentmanufacturers dissolve at differentrates. For this reason, some detergenttablets do not attain their full cleaningpower during short washingprogrammes. Therefore, please uselong washing programmes when usingdetergent tablets, to ensure thecomplete re...

When the washing programmehas finished, it is recommendedthat the dishwasher is unpluggedand the water tap turned off. Unloading the dishwasher • Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cooldown before removing from the appliance. • Empty the lower basket first ...

Frost precautions Avoid placing the machine in a location wherethe temperature is below 0°C. If this isunavoidable, empty the machine, close theappliance door, disconnect the water inletpipe and empty it. Moving the machine If you have to move the machine (movinghouse, etc...): 1. Unplug it.2. Turn ...

Technical data Dimensions WidthHeightDepth 60 cm85 cm60 cm Electrical connection - Voltage - Overallpower - Fuse Information on the electrical connection is given on therating plate on the inner edge of the dishwasher door. Water supply pressure MinimumMaximum 0,05 MPa (0,5 bar) 0,8 MPa (8 bar) Capa...

Remove the machine’s worktop byunscrewing the two rear retaining screws (1),pull the worktop from the back of the machine(2) and slide out the front slots, lifting theworktop (3). Insert the machine after adjusting the levellingwith the adjustable feet. When inserting themachine, ensure that the wat...

The water inlet hose must not be kinked,crushed, or entangled when it is beingconnected.The appliance features inlet and drain hoseswhich can be turned either to the left or theright to suit the installation by means of thelocknut. The locknut must be correctly fitted to avoid water leaks. (Attentio...

Electrical connection Warning! Safety standards require the appliance to be earthed.Prior to using the appliance for the firsttime, ensure that the rated voltage andtype of supply on the rating platematch that of the supply where theappliance is to be installed. The fuserating is also to be found on...

4. The purchase date (found on your receipt). 5. The model and serial number of the appliance (found on the rating plate). So that you always have these numbers athand, we recommend that you make a noteof them here:Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .PNC : . . ....