Page 2 - Signal Words; SAFETY
Take note! This safety alert symbol found throughout this manual is used to call yourattention to instructions involving your personal safety and the safety of others. Failure tofollow these instructions can result in injury or death. Signal Words Note the use of the signal words DANGER, WARNING and...
Page 3 - INDEX
31 PARTS MANUAL 28 7 - PRE-DELIVERY CHECKLIST 27 6 - TROUBLESHOOTING 26 5.02 - Storage 26 5.01 - Suggested Spare Parts 26 5 - REPAIR PROCEDURES 23 4.04 - Transport 22 4.03 - Driveline 22 4.02 - Service 21 4.01 - Maintenance Safety 21 4 - MAINTENANCE 20 3.07 - Uneven Terrain 17 3.06 - Operating Techn...
Page 4 - - GENERAL INFORMATION
1 - GENERAL INFORMATION Thank you and congratulations for having chosen our implement. Your new fertilizer spreader is atechnologically advanced machine constructed of high quality sturdy components that will fulfill yourworking expectations. Read this manual carefully. It will instruct you on how t...
Page 11 - - SAFETY PRECAUTIONS; goggles when filling hopper.
2 - SAFETY PRECAUTIONS Safety is the primary concern in the design and manufacture of our products. Unfortunately our effortsto provide safe equipment can be wiped out by a single careless act of an operator.In addition to the design and configuration of equipment, hazard control and accident preven...
Page 12 - damage before restarting.
3. The operating power is supplied from tractor PTO. Refer to your tractor manual for PTO engagement and disengagement instructions. Always operate PTO at 540 rpm. Know how to stopthe tractor and machine quickly in case of an emergency. 4. When engaging PTO, the engine rpm should always be low. Once...
Page 13 - right side
Safety decals - implement; replace immediately if damaged. F ERTILIZER S PREADERS O PERATOR ’ S M ANUAL S AFETY P RECAUTIONS 13 FRONTIER right side left side
Page 15 - DANGER: Shut off the tractor and remove the key before
16. Stay alert for holes, rocks and roots in the terrain and other hidden hazards. Keep away from drop-offs. 17. Use extreme care and maintain minimum ground speed when transporting on hillside, over rough ground and when operating close to ditches or fences. Be careful when turning sharp corners. 1...
Page 16 - Secure the two tractor hitch; Ground level
3.04 - Attaching to the Tractor Unit may be used on tractors ranging from 16 to 30 HP equipped with a standard rear PTO andcategory 1 three point hitch 6 . Never use this spreader with tractors over 30 HP. DANGER: Do not allow anyone to stand between spreader and tractor while attaching implement. W...
Page 17 - Before starting to use, never forget that the; operator is responsible
operation. If it was necessary to remove the PTO shielding to do any of the above operations, do notforget to replace it. 3.05 - Start Up CAUTION: Load hopper with product only after the spreader has been properly attached to thetractor. WARNING: Chemicals may cause eye, skin or breathing problems. ...
Page 21 - Refer to chemical
4 - MAINTENANCE DANGER: Stop engine, lock parking brake and remove key before performing any service ormaintenance.Always use personal protection devices, such as a breathing mask capable of filtering toxicpowders, safety glasses and gloves, when performing maintenance. Refer to chemical manufacture...
Page 22 - Before beginning work:; rusting areas that are difficult to clean.; If necessary add SAE 90 oil
16. Unauthorized modifications to the machine may impair the function and/or safety of the machine and reduce its life. If equipment has been altered in any way from original design, themanufacturer does not accept any liability for injury or warranty. 4.02 - Service Before beginning work: 1. Apply ...
Page 23 - roads or streets. Comply with all federal, state and local laws.
If determined that the driveline is too long, follow these procedures to adjust the length:1. Separate the two driveline halves. Connect one half to the tractor PTO and the other half to the implement. 2. Raise and lower the implement with the 3 point hitch to find the position where the driveline i...
Page 24 - TABLE 1 - TORQUE SPECIFICATIONS; TABLE 2 - FERTILIZER SPREADER - TECHNICAL FEATURES
TABLE 1 - TORQUE SPECIFICATIONS When using lock washers with nuts, increase torque values by 5%. 3557 4823 2194 2974 978 1326 12 1-1/2” 2607 3535 1830 2482 1131 1534 4 M36 3161 4286 1949 2643 869 1179 6 1-1/2” 1659 2250 1180 1600 738 1000 2 M30 2712 3677 1673 2268 746 1011 12 1-3/8” 1499 2033 1047 1...
Page 26 - - REPAIR PROCEDURES
5 - REPAIR PROCEDURES CAUTION: All repair procedures must be done by authorized dealerships. It is notrecommended that untrained individuals perform any repair work. 5.01 - Suggested Spare Parts It is suggested that the following spare parts be kept on hand for the spreader at all times to prevent a...
Page 27 - SOLUTION
6 - TROUBLESHOOTING WARNING: Be sure tractor engine is off, parking brake is locked, and key is removed beforemaking any adjustments. Increase PTO speed to 540 rpm. Shorten the tractor’s top link to positionspreader so it runs level or inclined slightlyforward toward the tractor. Incorrect PTO speed...
Page 31 - P A R T S M A N U A L; FERTILIZER SPREADERS
P A R T S M A N U A L FERTILIZER SPREADERS SS1023BSS1036BSS1067B SS2036BSS2067B Parts Manual 05/2011 203-120 Ver. D 206-121, 206-221 Ver. B 209-121, 209-421, 209-422 Ver. C Frontier Hop 203, 206, 209 (US)Printed on May 19, 2011 Note: Serial #’s with the XF prefix are subsequent to serial numbers wit...
Page 55 - Use only original spare parts
Use only original spare parts All rights reserved. It is unlawful to copy, reprint or use any of the information or details in this manualwithout the expressed written permission of the Company. Technical information provided in thismanual is approximate, the Company reserves the right to modify or ...