Jet JDP-15M/MF - Manuals - manualsarea.com

Page 2 - Warranty and Service

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authori zed Service Centers located throughout the United States can give you quick service. In most cases, any of these Walter Meier Authorized Service ...

Page 3 - Table of Contents

3 Table of Contents Table of Contents ...............................................................................................................................3 Warnings................................................................................................................................

Page 6 - Specifications

6 Specifications Model Number ............................................................ JDP-15M ........................................... JDP-15MF Stock Number .............................................................. 354165................................................ 354166 Swing........

Page 7 - Shipping Contents; Required Tools

7 Shipping Contents Unpack the carton and verify that all parts listed below are included. Main Parts 1 ea Head Assembly 1 ea Table 1 set Column and Table Bracket Assembly 1 ea Base Addit ional Parts 1. 1 set Chuck and Chuck Key 2. 1 pc Arbor 3. 1 pc Drift Key 4. 1 pc Table Crank Handle 5. 1 pc Tabl...

Page 8 - Assembly; Before Assembly

8 Assembly Read and understand all assembly instructions before attempting assembly! Failure to comply may cause ser ious injury! Before Assembly 1. Remove the contents from the shipping container. 2. Compare the contents of the shipping container with the list found above. Report any shortages or d...

Page 10 - Chuck and Arbor Removal; Adjustment; Depth Stop Adjustment

10 Figure 8 Chuck and Arbor Removal Referring to Figure 9: 1. Unplug machine from the power source. 2. Raise the table until it is about seven inches below the chuck. 3. Place a piece of scrap wood on t he table, and lower quill (A) using t he downfeed handle. 4. Rotate spindle to align t he keyhole...

Page 11 - Return Spring Adjustment

11 6. Tighten two bar knobs (E, Fig. 11). Belts are properly tensioned w hen finger and thumb pressure midway between t he two pulleys causes approximately ½” deflection. Figure 11 Figure 12 Return Spring Adjustment The ret ur n spring is adjusted at the factory and should not need further adjustmen...

Page 12 - Operation

12 Work Light Install a light bulb, no larger t han 60 watts into the socket accessed from beneath t he head. The rocker switch controls the light switch (D, Fig. 13). IMPORTANT: If the drill press is connected to 230 volt power, you must install a bulb rated for 230 volt. Table Tilt Adjustment The ...

Page 15 - Troubleshooting

15 Troubleshooting Trouble Probable Cause Remedy Drill press will not start. Drill press unplugged from wall, or motor. Check all plug connections. Fuse blown, or circuit breaker tripped. Replace f use, or reset circuit breaker. Cord damaged. Replace cord. Starting capacitor bad. Replace starting ca...

Page 21 - Wiring Diagram

21 Wiring Diagram JDP – 15M/MF – 115V JDP – 15M/MF – 230V

Page 22 - NOTES