Jet DC-650TS - Manuals - manualsarea.com

Page 3 - WARNING; Cord Length

3 WARNING 1. Read and understand the entire contents of this manual before attempting assembly oroperation. Do not use this machine until proper training and knowledge has been obtained. 2. Do not leav e Dust Collector when plugged in. Unplug from outlet when not in use and beforeserv icing. 3. Do n...

Page 4 - Grounding Instructions; Repair or replace a damaged or worn cord immediately.

4 Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the ev ent of a malfunction or breakdown, grounding prov ides a path of least resistance for electriccurrent to reduce the risk of electric shock. This tool is equipped with an e...

Page 5 - Disconnect the machine from the power source.

5 230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the power source. 2. This dust collector is supplied with four motor leads that are connected for 115V operation, as shownin Figure A. Reconnect these four mot...

Page 7 - Read and understand the entire contents of; Unpacking

7 WARNING Read and understand the entire contents of this manual before attempting assembly or operation of the dust collector! Failure to comply may cause serious injury! Unpacking 1. Finish remov ing all contents from theshipping carton. 2. Report any damage to your distributor. 3. Do not discard ...

Page 8 - Assembly; Tighten the; This will prev ent

8 Assembly WARNING The dust collector must be disconnected from the power source during assembly. Failure to comply may result in serious injury! The JET DC-650TS does not come with acollector can. You can use the JET two stagedust collector on a v ariety of round, metal andplastic collector cans. T...

Page 9 - Electrical Connections; Turning the Machine On & Off; Motor

9 Electrical Connections WARNING All electrical connections must be done by a qualified electrician. All adjustments or repairs must be done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury! The DC-650TS dust collector is rated 115...

Page 10 - Cleaning the Filter; CAUTION; Emptying the Collector Can

10 Cleaning the Filter CAUTION Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recommended. Clean both the filter and collector can frequentlyto keep the collector's performance at itsoptimum. To clean: 1. Disconnect the machine from the powers...

Page 11 - Parts Breakdown

Page 12 - Parts List for the DC-650TS; Index

12 Parts List for the DC-650TS Index Part No. No. Description Size Qty. 1 .......... 331019AW ................... Impeller Housing (upper) ....................... ............................................... 12 .......... 331019BW ................... Impeller Housing (lower) ........................

Page 13 - Wiring Diagram