Jet DC-1200FS - Manuals - manualsarea.com

Page 2 - Important Information; JET offers a two-year limited; LIMITED WARRANTY; warranty on this product; Visa, MasterCard, or Discov er Card number; REPLACEMENT PART WARRANTY; JET Equipment & Tools

2 Important Information 2-YEAR JET offers a two-year limited LIMITED WARRANTY warranty on this product REPLACEMENT PARTS Replacement parts for this tool are av ailable directly form JET Equipment & Tools.To place an order, call 1-800-274-6848. Please hav e the following information ready:1. Visa...

Page 3 - WARNING; Do not use outdoors or on wet surfaces.; Cord Length; SAVE THESE INSTRUCTIONS

3 WARNING 1. Read and understand the entire contents of this manual before attempting assembly oroperation. Do not use this machine until proper training and knowledge has been obtained. 2. Do not leav e Dust Collector when plugged in. Unplug from outlet when not in use and beforeserv icing. 3. Do n...

Page 4 - Grounding Instructions; Repair or replace a damaged or worn cord immediately.

4 Grounding Instructions Caution! This tool must be grounded while in use to protect the operator from electric shock. In the ev ent of a malfunction or breakdown, grounding prov ides a path of least resistance for electriccurrent to reduce the risk of electric shock. This tool is equipped with an e...

Page 6 - Read and understand the entire contents of; Unpacking

6 WARNING Read and understand the entire contents of this manual before attempting assembly or operation of the dust collector! Failure to comply may cause serious injury! Unpacking 1. Remov e all contents from the shippingcarton. 2. Report any damage to your distributor. 3. Do not discard any shipp...

Page 7 - Assembly; The dust collector must be disconnected; Position the base on its side. Mount the two

7 Assembly WARNING The dust collector must be disconnected from the power source during assembly (unplug). Failure to comply may result in serious injury! 1. Position the base on its side. Mount the two front, fixed casters on the base with four M6M6x12 hex cap screws, four lock washersand four M6 f...

Page 10 - Turning the Machine On & Off

10 11. Slide the hook on the bag hanger through the top loop on the filter bag. Thread theretainer strap (A, Fig. 10) through the loopson the filter bag (B, Fig.10), and tightlysecure to the upper housing. The retainerstrap should be tight enough to prov ide agood seal. 12. Place the plastic collect...

Page 11 - Connect the machine to the power source.; Motor; Make frequent inspections of the motor and; Electrical Connections; All electrical connections must be done by a; If it is necessary to run this unit on 230V,

11 3. Loosen the bag clamp, and remov e thecollector bag from the dust collector.Empty the contents into a fire proof metalcontainer. 4. Attach a new bag using the bag clamp tosecure. 5. Connect the machine to the power source. Note: Use the proper type hose to connect thedust collector to the machi...

Page 12 - Parts Breakdown

Page 13 - Parts List for the DC-1200FS; Index

13 Parts List for the DC-1200FS Index Part No. No. Description Size Quantity 1 .......... 427001 ......................... Upper Housing....................................... .................................. 12 .......... 427074 ......................... Pad..........................................

Page 14 - Wiring Diagram

14 55 ........ ST039304 .................... Tapping Screw....................................... M3.5x12 ................... 1156 ........ ST040200 .................... Tapping Screw....................................... M4x10 ...................... 2857 ........ TS-1550041 ................. Flat ...