Page 2 - Warranty and Service; More Information
2 This manual has been prepared for the owner and operators of JET DC-1100 Series Dust Collectors. Its purpose, aside from machine operation, is to promote safety using accepted operating and maintenance procedures. To obtain maximum life and efficiency from your dust collector and to aid in using i...
Page 3 - Table of Contents; Parts List –; Parts Breakdown –; DC
3 Table of Contents Warranty and Service ........................................................................................................................................... 2 Table of Contents.......................................................................................................
Page 4 - not
4 Warnings 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they become obscur...
Page 5 - careless acts that can result in serious injury.
5 blahblahblah 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious injury. 22. Do not use the dust collector for...
Page 7 - Unpacking; Remove all contents from the shipping carton.; Contents of the Shipping Carton; Bag of Assembly Hardware
7 Unpacking DC-1100A/RC Dust Collector 1. Remove all contents from the shipping carton. 2. Report any damage to your distributor. 3. Do not discard any shipping material until after the dust collector has been assembled and is running properly. Contents of the Shipping Carton 1 – Upper Bag Hanger 1 ...
Page 8 - Canister Filter Box; Tools Required for Assembly; Bag of Hardware for Handles
8 Unpacking DC-1100C/RC Dust Collector 1. Remove all contents from the shipping carton. 2. Report any damage to your distributor. 3. Do not discard any shipping material until after the dust collector has been assembled and is running properly. Contents of the Shipping Carton Canister Filter Box 1 –...
Page 9 - Assembly; Base; four; Motor and Fan Assembly; Place the base with casters on the ground. Attach; The dust collector must not be; eight M; To reduce the risk of injury from; Figure 1
9 Assembly Base 1. Install four casters to the under side of the base as pictured in Fig. 2. 2. Thread the hex nut (B, Fig. 1) onto the caster shaft. Then slide the lock washer (A, Fig. 1) over the caster shaft. Thread the caster shaft into the threaded hole on the underside of the base, turn until ...
Page 11 - Referring to Figure 7:; Collector Bag Installation – DC-1100A/RC; Referring to Figure 8:
11 Filter Bag Installation – DC-1100A/RC Referring to Figure 7: 1. Place the hanger (A) on the hanger bracket (B). 2. Slide the filter bag loop (C) over the hanger hook. 3. Thread the retainer strap (D) through the loops on the filter bag (E) and fasten to the collector housing (F). Collector Bag In...
Page 12 - Figure 9
12 Collector Bag Installation – DC-1100C/RC 1. Place the ring over the top of the plastic bag and fold over the bag approximately three inches, Figure 9. 2. Insert the snap ring (A, Fig. 10) of the collector bag into the bottom of the housing at an angle. 3. Pull down on the ring to make sure it “se...
Page 13 - Electrical Connections; All electrical connections must; Turning the Machine On & Off; Setting the Timer
13 Electrical Connections All electrical connections must be done by a qualified electrician. All adjustments or repairs must be done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury! The DC-1100A/RC and DC-1100C/RC dust collectors...
Page 14 - Maintenance; Collector; Collector
14 Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury! Cleaning the Filter Bag – DC-1100A/RC Wearing a particle mask or respirator for protection against fine dust particles during cleaning i...
Page 15 - Description
15 Parts List – DC -1100A/RC Dust Collector Index No. Part No. Description Size Qty 1 ............... 411035W ................. Impeller Housing.....................................................................................................1 2 ............... 411026W ................. Motor Bra...
Page 18 - Remote Control Breakdown for DC-1100RC
18 Remote Control Breakdown for DC-1100RC Index No. Part No. Description Size Qty ................. DC1100RC-100 ....... Receiver Assembly (Items 1-12) ............................................................................1 1 ............... DCRC-101 ............... Label ........................
Page 20 - Wiring Diagram – DC-1100RC