Page 2 - Warranty and Service
2 JAT-920 Pneumatic Riveter Warranty and Service JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty ...
Page 3 - Safety warnings; General air tool warnings
JET 3 Safety warnings General air tool warnings 1. Read and understand this entire manual before attempting assembly or operation. 2. Read and understand all warnings posted on the tool and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace warning la...
Page 4 - Specific warnings for Riveters
4 JAT-920 Pneumatic Riveter 25. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious injury. 26. Do not force a tool or attachment to do a job for which it was not designed. The right tool will do the job bette...
Page 6 - Setup and Assembly; Operation
6 JAT-920 Pneumatic Riveter Setup and Assembly Any missing parts or damage should be reported immediately to your JET ® distributor. Do not use a damaged tool. Read this instruction manual thoroughly for operation, maintenance and safety instructions. Box contents: 1 Pneumatic riveter 1 Safety cap...
Page 7 - Maintenance; Lubrication; Storage
JET 7 Maintenance Lubrication The air riveter should be lubricated daily (or before each use) with air tool oil through the air inlet. During continual operation, it should be re-oiled every 1 to 2 hours. This can be done with an in-line oiler, or manually. If done manually, proceed as follows: 1....
Page 8 - Rule of Thumb
8 JAT-920 Pneumatic Riveter 6. Air-line pressure may be increased accordingly to compensate for extra-long air hoses (usually over 25 feet). Inside diameter of hose should be minimum 3/8-inch. General Air Tool Information If the air tool is not performing according to specifications, the following...
Page 10 - Troubleshooting JAT-920 Pneumatic Riveter
10 JAT-920 Pneumatic Riveter Troubleshooting JAT-920 Pneumatic Riveter Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Riveting force insufficient. Air valve ob...
Page 11 - Replacement parts
JET 11 Replacement parts Service parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serve...