Page 2 - Warranty and Service
2 JAT-730,731 Random Orbit Palm Sander Warranty and Service JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The genera...
Page 3 - Safety warnings; General air tool warnings
JET 3 Safety warnings General air tool warnings 1. Read and understand this entire manual bef ore attempting assembly or operation. 2. Read and understand all warnings posted on the tool and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace warning l...
Page 4 - Specific warnings for Sanders
4 JAT-730,731 Random Orbit Palm Sander 20. Do not use power tools in damp or wet location, or expose them to rain. Keep work area well lighted. 21. Do not leave a connected tool unattended. W hen not in use, disconnect tool from air source. 22. Shut off air supply and discharge any residual pressu...
Page 5 - About this manual
JET 5 About this manual This manual is provided by JET, covering the saf e operation and maintenance procedures f or a JET Model JAT-730 and JAT-731 Pneumatic Random Orbit Palm Sander This manual contains instructions on saf ety precautions, general operating procedures, maintenance procedures and...
Page 6 - Tool specifications
6 JAT-730,731 Random Orbit Palm Sander Tool specifications Model number JAT-730 JAT-731 Stock number 505730 505731 Pad size 5 in. round 6 in. round Orbit diameter 3/16 in. 3/16 in. Horsepower 0.25 0.25 Spindle thread 5/16”-24 UNF 5/16”-24 UNF Free speed 12,000 RPM 12,000 RPM Average air consumptio...
Page 7 - Maintenance; Lubrication
JET 7 Setup and Assembly Any missing parts or damage should be reported immediately to your JET ® distributor. Do not use a damaged tool. Read this instruction manual thoroughly for operation, maintenance and saf ety instructions. Box contents: 1 Palm sander 1 Open end wrench, 24mm 1 Operation and...
Page 8 - Rule of Thumb
8 JAT-730,731 Random Orbit Palm Sander 3. Re-connect air. Run sander at low throttle without load for a f ew seconds to distribute the oil throughout tool. 4. W hen finished operating sander, disconnect air hose. W ipe off housing with a dry cloth. Place 4 or 5 drops of air tool oil into air inlet...
Page 10 - Troubleshooting JAT-730/731 RO Palm Sander
10 JAT-730,731 Random Orbit Palm Sander Troubleshooting JAT-730/731 RO Palm Sander Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valv...
Page 11 - Replacement parts
JET 11 Replacement parts Replacements are listed on the f ollowing pages. T o order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serv...
