JENSEN BT250 - Manuals

Bluetooth Car Kit User Manual 2 Installing the junction box This Car Kit is designed to work with a 12/24-volt vehicle power supply. Refer to the following to install the junction box in a vehicle. 1. Locate a suitable place inside the car to mount the junction box. Select a dry place that avoids ex...

Connecting the power supply The following illustration demonstrates how to connect the Car Kit’s power cable to the vehicle’s electrical system. Power Cable Important! The Blue cable must be connected to the 12/24-volt switched ignition to enable the Car Kit to go into standby mode. Do not connect t...

Bluetooth Car Kit User Manual Connecting Components The following illustration shows where to connect the devices. Do not connect the components until you have followed the next steps and have finalized your installation. Ò CONNECT THE POWER HARNESS LAST. Junction box Speaker Microphone Remote Contr...

Installing the Components Before installing the components, take note of the following: • Make sure that the cables can reach from the each component to the Junction Box. If the cable is too short, relocate the component. Do not lengthen the cable. • The supplied microphone is uni-directional. For b...

Bluetooth Car Kit User Manual 6 G G e e t t t t i i n n g g S S t t a a r r t t e e d d Introduction The Bluetooth Wireless Car Kit is designed to help make your driving experience more convenient, safe, and provide you with years of trouble free use. Product overview and features The Car Kit is des...

Using the remote control The Car Kit is operated using the remote control: Control Module Functions Volume up / down Press during operation to increase or lower the volume. Answer / redial Press to answer a call. Call waiting: Press to answer a second call. Press again to return to the first call. P...

Bluetooth Car Kit User Manual 8 Disconnect / voice recognition Press to disconnect a call. Press and hold for two seconds to activate the Voice Recognition function. After the tone, repeat your pre-recorded voice tag: the number automatically dials. Press to reject an incoming call. *Phone MUST Supp...

Bluetooth Car Kit User Manual 10 Resetting the Car Kit The car kit may only connect to one phone at a time. However, it may be paired with up to 4 phones. Resetting the car kit deletes all pairings. To do so: Press and hold the Answer/redial and Volume down at the same time. You will hear a tone (pa...

the way you say the voice tag, but also record a familiar background noise. Since phones are in continual contact with the Car Kit, it is possible to use the included Car Kit’s microphone to record the voice tag. Locate the feature on your mobile phone, and when prompted for the voice tag, speak cle...

Bluetooth Car Kit User Manual 12 Troubleshooting My mobile phone can’t make a connection. • Make sure the bluetooth function on your phone is enabled. • Make sure the car ignition is on. If on and no power check the fuses and wiring. • Reset the Car Kit and try again. • Turn your phone off and on ag...

Warranty Information 1 2 MONT H L IMITED WARRANTY Applies to Je nsen Series Mobile Electronics. AUDIOV OX Ele ctronics Corporation (the Compa ny) war rants to the o riginal retail pur chas e r of th is product that should this produ ct or any pa rt the reof, (oth er than transmitters) und er normal ...