JennAir JJW3830IM00 - Manuals

Page 2 - INSTALLATION REQUIREMENTS; Tools and Parts; Gather the required tools and parts before starting; Tools Needed; Location Requirements

2 BUILT-IN OVEN SAFETY INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■ Phillips screwdriver ■ Measuring tape ■ Hand or electric drill (for wall cabinet ins...

Page 5 - Electrical Requirements; Electrical Connection

5 Electrical Requirements If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and the wire gauge are in accordance with local codes.Check with a qualified electrical installer if you are not sure the oven is prope...

Page 6 - INSTALLATION INSTRUCTIONS; Prepare Built-In Oven; WARNING

6 INSTALLATION INSTRUCTIONS Prepare Built-In Oven 1. Decide on the final location for the oven. Avoid drilling or cutting into house wiring during installation. 2. To avoid floor damage, set the oven onto cardboard prior to installation. Do not use handle or any portion of the front frame for liftin...

Page 7 - Single Ovens

7 Replace Oven Door(s) 1. Using two hands, grasp side edges of door at the midpoint. Face the oven cavity. 2. Locate the slots on each side of the oven front frame for the door hinge locks. 3. Using two hands, grasp the edges of the oven door. At a 45° angle, insert the hinges at the same time, and ...

Page 10 - Cutout Height Is Between 50

10 Cutout Height Is Between 50 1 / 2 " and 51 1 / 8 " (128.2 cm and 129.9 cm) 1. Using 2 or more people, place the oven on its back on a covered surface. 2. Install a foot on the left rear spacer using a #8-18 x 3/8" (9.5 mm) screw. NOTE: Position the foot so the long side of the foot is...

Page 11 - Cutout Height Is Between 51

11 Cutout Height Is Between 51 3 / 16 " and 52 3 / 16 " (130 cm and 132.6 cm) 1. Using 2 or more people, place the oven on its back on a covered surface. 2. Install a foot on the left rear spacer using a #8-18 x 3/8" (9.5 mm) screw. NOTE: Position the foot so the short side of the foot i...

Page 12 - Make Electrical Connection; For Double Ovens

12 Make Electrical Connection For Double Ovens This oven is manufactured with a neutral (white) power supply wire and a cabinet-connected green (or bare) ground wire twisted together. 1. Disconnect power. 2. Feed the flexible conduit from the oven through the opening in the cabinet. 3. Remove juncti...

Page 13 - Install Oven

13 3-Wire Cable from Home Power Supply - U.S.A. Only IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. 1. Connect the 2 black wires (C) together using a UL listed wire connector. 2. Connect the 2 white wires (D) and the green (or bare) ground wire (...

Page 15 - Parts Supplied in Deflector Kit; Complete Installation; Check Operation of Single and Double Ovens

15 Install Warming Drawer Deflector Kit (Only for Ovens Installed Above Warming Drawers) On single and double oven models installed above a warming drawer, a warming drawer deflector kit must be installed. See the “Tools and Parts” section for information on ordering. Parts Supplied in Deflector Kit...