Page 2 - INSTALLATION; POWER CONNECTIONS; Do not; Remote Connection; must
INSTALLATION WARNING: Playing loud music in an automobile can hinder your ability to hear traffic and permanently damage your hearing. We recommend listening at low or moderate levels whiledriving your car. JBL accepts no liabilityfor hearing loss, bodily injury orproperty damage resulting from the ...
Page 3 - APPLICATIONS – BPX MODELS; Figures 1 through 3; BPx Amplifier; jumper; The JBL Power Series; BPx Amplifier
APPLICATIONS – BPX MODELS To the right are several application diagrams to help plan your subwoofersystem installation. Figures 1 through 3 show how to configure the JBL PowerSeries subwoofer amplifiers (modelsBPx500.1, BPx1100.1 and BPx2200.1) for2-channel, bridged-mono and parallel-mono operation ...
Page 4 - Figures 4 and 5
4 APPLICATIONS – PX600.2 The JBL Px600.2 amplifier can be set up for stereo or bridged-mono oper-ation, as shown in Figures 4 and 5 . NOTE: For simplicity, Figures 4 and 5 do not show power, remote and inputconnections. Px600.2 (rear panel) POWER FUSES GND REM BATT SPEAKER OUTPUTS BRIDGED STEREO Px6...
Page 5 - Figures 6 and 7; Subwoofer; Set REAR; LR Speaker; Set REAR and FRONT
5 APPLICATIONS – PX300.4 The JBL Px300.4 amplifier can be set upfor stereo or tri-mode operation, asshown in Figures 6 and 7 . NOTE: For simplicity, Figures 6 and 7 do not show power, remote and input connections. Px300.4 (rear panel) POWER FUSES GND REM BATT Px300.4 SPEAKER OUTPUTS SPEAKER OUTPUTS ...
Page 6 - INSTALLATION AND SETUP; on page; DBO HP FREQ Control; DBO BOOST Control; (adjusts boost amount
6 INSTALLATION AND SETUP SETTING THE OUTPUT MODE Setting an output mode depends onyour choice of system configuration andthe nominal impedace of your speakersystem. JBL Power Series BPxamplifiers provide rated power into any impedance between 1 and 4 ohms.The BPx500.1, BPx1100.1 and BPx2200.1amplifi...
Page 7 - Figure 9; End Panel; TROUBLESHOOTING; SYMPTOM
7 INSTALLATION AND SETUP For sealed enclosures, use DBO toenhance the middle of the bass region.Set the HP FREQ control to 35Hz to 40Hzand adjust the BOOST control to taste.This will make the bass sound biggerand fuller. Alternatively, for tighter-sounding bass, set the HP FREQ controlbetween 45Hz a...
Page 8 - SPECIFICATIONS; Declaration of Conformity; English
Px300.4 Px600.2 BPx500.1 BPx1100.1 BPx2200.1 Power Output, 75W x 4 150W x 2 N/A N/A N/A 4 Ohms Power Output, 150W x 4 300W x 2 250W x 2 575W x 2 1100W x 2 2 Ohms Power Output, 300W x 2 600W x 1 500W x 1 1100W x 1 2200W x 1 Bridged, 4 Ohms Power Output, N/A N/A 500W x 1 1100W x 1 2200W x 1 Parallel, ...