JBL CS680 (230V) - Manuals - manualsarea.com

Page 2 - Important Safety Precautions!

2 READ FIRST! Important Safety Precautions! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.Install in accordance with themanufa...

Page 3 - English; THANK YOU FOR CHOOSING JBL

3 English Before deciding where to best place your speakers, survey yourroom and study Figures 1 and 2. Figure 1. In this overhead view of a typical installation, satellite speakers are used to reproduce sound for the front and surroundchannels. The center channel reproduces sound and dialogue. The ...

Page 4 - PLACEMENT; Left and Right Front Channels

4 PLACEMENT Left and Right Front Channels For left and right front channels, place one satellite to the left and another to the right of the television, as shown in Figure 1. Since the speakers are magnetically shielded, you can place them very close to the TV without worrying about the magnetic fie...

Page 5 - Fixed-Mount Wall Bracket; WALL-MOUNTING THE SATELLITES AND CENTER CHANNEL

5 English The CS680 satellites and center channel are designed to be mountedon the wall. There is a fixed-mount wall bracket and an adjustablewall bracket provided for each satellite and the center channel.Each speaker bracket will require up to four 1-1/2" #10 wood screws;each screw should be f...

Page 6 - On certain models using hexagonal terminal nuts, a small; CENTER AND SATELLITE SPEAKER CONNECTIONS

6 Turn Off All Power After placing the speakers, you are ready to connect your system.First, turn off all audio-system power. Use high-quality speaker wireto make your connections. #18-gauge speaker wire with polaritycoding is included. For longer distances, #16-gauge or heavier wireis recommended. ...

Page 7 - SUBWOOFER CONTROLS; Rear Panel; Subwoofer Connections; Subwoofer cable

7 English SUBWOOFER CONTROLS Rear Panel AC 220V-230V 50Hz-60Hz 220 Watts PHASE CS80SUB/230 ¡ ™ £ ¢ ∞ § Subwoofer-Level Control Phase Switch LFE Input Line-Level Inputs Power Indicator LED Power Switch Subwoofer Connections If you have a Dolby ® Digital or DTS ® receiver/processor with a low-frequenc...

Page 8 - OPERATION

8 OPERATION Surround Modes When using the CS680 in a Dolby Digital or DTS home theatersystem, make sure all speakers are set to “Small”. In a Dolby ProLogic ® home theater system, make sure the receiver’s center channel mode is set to “Normal.” Some Dolby Digital-equipped receivers/processors offer ...

Page 9 - SATELLITES; SPECIFICATIONS

9 English † The Peak Dynamic Power is measured by recording the highest center-to-peak voltagemeasured across the output of a resistive load equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off. CS680 SATELLITES Frequency Response (– 6dB): 100Hz – 20...

Page 10 - PRO SOUND COMES HOME

All features and specifications are subject to change without notice. JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. Pro Sound Comes Home is a trademarkof Harman International Industries, Incorporated. Dolby and Pro Logic ...