JBL CS6100 - Manuals - manualsarea.com

Page 3 - IMPORTANT SAFETY INSTRUCTIONS

3 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install...

Page 4 - INCLUDED; THANK YOU FOR CHOOSING JBL

For more than 60 years, JBL has been involved in every aspect ofmusic and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We’re confident that the JBL system you have chosen will provideevery note of enjoyment that you expected – and th...

Page 5 - PLACEMENT; Left and Right Front Channels

5 PLACEMENT Left and Right Front Channels For left and right front channels, place one satellite to the left and another to the right of the television, as shown in Figure 1. Since the speakers are magnetically shielded, you can place them very close to the TV without worrying about the magnetic fie...

Page 7 - On certain models using hexagonal terminal nuts, a small

Turn Off All Power After placing the speakers, you are ready to connect your system.First, turn off all audio-system power. Use high-quality speaker wire to make your connections (#18-gauge speaker wire with polarity coding is included). For longer distances, #16-gauge or heavier wire is recommended...

Page 8 - SUBWOOFER CONTROLS; Rear Panel; NOTE; Subwoofer cable

SUBWOOFER CONTROLS Rear Panel 1 Phase Switch 2 LFE Input 3 Line-Level Inputs 4 Power Indicator LED 5 Subwoofer-Level Control 6 Power Switch Subwoofer Connections If you have a Dolby ® Digital or DTS ® receiver/processor with a low-frequency-effects (LFE) or subwoofer output: § R ISK O F E LEC TR ICS...

Page 9 - OPERATION

OPERATION Surround Modes When using the CS6100 speakers in a Dolby Digital or DTS home theater system, make sure all speakers are set to “Small”. In aDolby Pro Logic ® home theater system, make sure the receiver’s center channel mode is set to “Normal.” Some Dolby Digital-equipped receivers/processo...

Page 10 - SPECIFICATIONS

10 † The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the output of a resistive load equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off. CS6100 SATELLITES Frequency Response (– 6dB): 100Hz – 20kHz R...

Page 12 - DTS is a registered trademark of DTS, Inc.; PRO SOUND COMES HOME

All features and specifications are subject to change without notice. JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. Pro Sound Comes Home is a trademarkof Harman International Industries, Incorporated. Dolby and Pro Logic ...