Page 2 - TABLE OF CONTENTS; WARNING; SAFETY DEFINITIONS
IMPORTANT SAFETY INSTRUCTIONS………………………....…………………………………… INSTALLATION REQUIREMENTS …………………………………...................…......……………. Parts Supplied …………………………………………………................................…………. Location Requirements ………………………………………….........………………………… Ventilation Requirements …………………………………………...
Page 3 - IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE FOLLOWING: • Use this unit only in the manner intended by the manufacturer. • Make sure that the voltage indicated on the rating plate of the appliance corresponds to your outlet voltage.• Do not attempt to alter the...
Page 5 - INSTALLATION REQUIREMENTS
INSTALLATION REQUIREMENTS PARTS SUPPLIED: Exhaust Duct Cover (Upper and Lower) Exhaust Duct Base Duct Cover Mounting Bracket Range Hood RHW-3687 (36in) x 1RHW-4813 (48in) x 1 RHW-3687 (36in) x 1RHW-4813 (48in) x 1 Exhaust Duct Cover Screws 4Mx6 RHW-3687 (36in) x 4RHW-4813 (48in) x 4 Exhaust Duct Bas...
Page 6 - LOCATION REQUIREMENTS:; PRIOR TO INSTALLATION:
• Unpack range hood and ensure all listed parts are in the box.• It is recommended for the vent system to be installed before hood is installed. • Before making cutouts, make sure there is proper clearance within the ceiling or walls for the exhaust vent. • It is recommended that a professional inst...
Page 7 - VENTILATION REQUIREMENTS:; Height and Clearance
VENTILATION REQUIREMENTS: Height and Clearance To reach 9 ft (2.74 m) ceiling, make sure range hood is installed at least 30 in. (762 mm) from cooking surface. 110 in. (2794 mm) 36 in. (914 mm) 24 in. (610 mm) Min / 30 in. (762 mm) Max recommended • This range hood must be ventilated to the outdoors...
Page 8 - FOR THE MOST EFFICIENT OPERATION:; ELECTRICAL REQUIREMENTS:
• Minimum mount height between cook top to hood bottom should be no less than 24’’ for electric cook tops or 30’’ for gas stove tops, and no higher than 30’’. • It is important to install the hood at the proper mounting height. Hoods mounted too low could result in heat damage or a fire hazard; whil...
Page 9 - INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS • It is recommended for the vent system to be installed before hood is installed. • Before making cutouts, make sure there is proper clearance within the ceiling or walls for the exhaust vent. • Disconnect the power. • A minimum of 6” (RHW-3687 model) and 8” (RHW-4813 model...
Page 11 - INSTALL THE RANGE HOOD:
1. Measure the distance between stove top and the bottom of range hood. A distance between 24” to 30” is required. For gas stove tops, a minimum distance of 30’’ is required.Make sure the range hood is level and not tilted. 2. Mark the locations of the Wall Mounting Bracket holes on the wall.Make su...
Page 13 - GROUNDING INSTRUCTIONS:
To install Baffle Filters: A. Install the baffle filters by inserting at an angle towards the rear B. Push the filter up and insert front of filter into front recess C. Slightly lower the filter then slide back until it is in proper position 18. Turn power ON on the Control Panel. Check all lights a...
Page 14 - RANGE HOOD USE; OPERATING THE RANGE HOOD:
- To Turn the Fan ON press the Power Button and press the “+” button to increase the fan speed: • Press “+” Once - Low (Digital Display shows F1) • Press “+” Twice - Medium/Low (Digital Display shows F2) • Press “+” Three Times - Medium/High (Digital Display shows F3) • Press “+” Four Times - High (...
Page 15 - RANGE HOOD CARE
CLEANING & MAINTENANCE: REMOTE CONTROL: WARNING: To reduce the risk of electrical shock, DO NOT clean the hood while it's operating. WARNING: Never put your hands into the area housing the fan when the fan is operating. RANGE HOOD CARE IMPORTANT: Clean the hood, grease tray, and baffle filters f...
Page 17 - TROUBLESHOOTING
TROUBLESHOOTING If the range hood or LED light does not operate after installation: The range hood vibrates when the blower is on: The blower or fan seems weak: The lights work but the fan is not spinning at all, is stuck or is rattling. The hood is not venting out properly. Check if the range hood ...
Page 18 - SPECIFICATIONS
17 SPECIFICATIONS Body Design Stainless Steel Power RatingTotal Input Power 224 W (218 W + 2x 3 W) Motor Input Power 218 W Amperage 2.5 A Speed Control Levels 4 Speeds Interference Protection Radio Frequency Interference Protected Motor Single Motor Control LCD Display Control, Remote Control Filtra...
Page 20 - S W E D E N; JANSKA USA; If you are not happy with the product for any reason,; Your purchase comes with a 100%; satisfaction guarantee from Janska
S W E D E N JANSKA USA 5175 Commerce Dr, Baldwin Park, CA [email protected] If you are not happy with the product for any reason, please contact us at [email protected] with your feedback or questions, and we will do our best to make things right for you! Your purchase comes with a 100% satisfaction...
