Page 2 - TABLE OF CONTENTS; WARNING; SAFETY DEFINITIONS
IMPORTANT SAFETY INSTRUCTIONS……………………………………………...............……… INSTALLATION REQUIREMENTS ………………………………………………….......……………. Parts Supplied …………………………………………………………….........................……. Location Requirements ………………………………………………......……………………… Ventilation Requirements ……………………………………….........…………...
Page 3 - IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE FOLLOWING: • Use this unit only in the manner intended by the manufacturer. • Make sure that the voltage indicated on the rating plate of the appliance corresponds to your outlet voltage.• Do not attempt to alter the...
Page 5 - INSTALLATION REQUIREMENTS; PRIOR TO INSTALLATION:
INSTALLATION REQUIREMENTS PARTS SUPPLIED: Power cord (attached to the Range Hood) Baffle Filter Spacer Wall Anchor Range Hood • Unpack range hood and ensure all listed parts are in the box.• It is recommended for the vent system to be installed before hood is installed. • Before making cutouts, make...
Page 6 - LOCATION REQUIREMENTS:
Ceiling Height Under Cabinet Range hood 36” Counter Top Max: 36” 24” (610 mm) Min / 36” (914 mm) Max Min: 24” Range Hood Height Cabinet Height Countertop/Stove This range hood has been designed to be installed under-cabinet, above a stove/hob. Before start-ing the installation, consideration should ...
Page 7 - FOR THE MOST EFFICIENT OPERATION:; ELECTRICAL REQUIREMENTS:
• Minimum mount height between cook top to hood bottom should be no less than 24’’ for electric cook tops or 30’’ for gas stove tops, and no higher than 30’’ for electric cook tops or 36’’ for gas cook tops. • It is important to install the hood at the proper mounting height. Hoods mounted too low c...
Page 8 - INSTALLATION INSTRUCTIONS
• This range hood is factory set for venting through the roof or wall. • Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. INSTALLATION INSTRUCTIONS • It is recommended for the vent system to be installed before hood is installed. • Before making...
Page 9 - ADVANCED PREPARATION:
VerticalRoof Venting Roof cap Option 2: Side wall cap HorizontalWall Venting Option 1: 1. Place the range hood on a flat, stable surface. Connect the power cord of the range hood to a designated standard outlet, 110̃120V/60Hz, AC only and turn the range hood ON. Verify all oper - ations of the range...
Page 10 - A - Attach the Range Hood Directly to the Kitchen Wall Cabinet:; INSTALL THE RANGE HOOD:
CAUTION: If moving the cooking range is necessary to install the hood, ensure the power of an electric range is turned OFF at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE. 4. For installing under the cabinet with recessed bottom, it is recommended (but not necessary) to attach...
Page 11 - B - Attach the Range Hood to the Wall Via Wall Mounting Bracket
WALL B - Attach the Range Hood to the Wall Via Wall Mounting Bracket B-1. Using references in Height & Clearance on Page 5, mark the leveling point of the hood. Using the 2 top holes of the Wall Mounting Bracket (Part G) as a guide, insert two Wall Anchor Screws (Part F) on the wall, leaving 1/8...
Page 13 - RANGE HOOD USE; OPERATING THE RANGE HOOD:
- To Turn the Fan ON press the Power Button and press the “+” button to increase the fan speed: • Press “+” Once - Low (Digital Display shows F1) • Press “+” Twice - Medium/Low (Digital Display shows F2) • Press “+” Three Times - Medium/High (Digital Display shows F3) • Press “+” Four Times - High (...
Page 15 - RANGE HOOD CARE
CLEANING & MAINTENANCE: WARNING: To reduce the risk of electrical shock, DO NOT clean the hood while it's operating. WARNING: Never put your hands into the area housing the fan when the fan is operating. RANGE HOOD CARE IMPORTANT: Clean the hood, grease tray, and baffle filters frequently accord...
Page 16 - TROUBLESHOOTING
1. If the range hood does not operate after installation: • Check if the range hood has been plugged in, make sure that all power has been turned back on and all electrical wiring is properly connected. • Swap out the light assembly to working ones to determine whether it is caused by defective bulb...
Page 17 - SPECIFICATIONS
6 SPECIFICATIONS Power: 120V/60HzDimensions: RHC-3092 - 29.3/4in x 22in x 10inRHC-3692 - 35.3/4in x 22in x 10inRHC-4892 - 47.3/4in x 22in x 10in Weight: RHC-3092 30in - 48.4lbs RHC-3692 36in - 52.8lbs RHC-4892 48in - 62.7lbs Baffle Filter size: RHC-3092 30in - 14in x 14.7in x 0.6inRHC-3692 36in - 14...
Page 20 - S W E D E N; JANSKA USA; If you are not happy with the product for any reason,; Your purchase comes with a 100%; satisfaction guarantee from Janska
S W E D E N JANSKA USA 5175 Commerce Dr, Baldwin Park, CA [email protected] If you are not happy with the product for any reason, please contact us at [email protected] with your feedback or questions, and we will do our best to make things right for you! Your purchase comes with a 100% satisfaction...
