InSinkErator ISE Evolution 100 - Manuals

5 10 C 11 C 12 C D E F G > 3/8” 1-1/8” H E F < 3/8” 1-1/2” G F E 14 Optional 13 I Evenly apply 1/2” thick rope ofplumber’s putty around flange(C). Press flange (C) firmly into sinkdrain. Remove excess putty. Insert fiber gasket (D), backupflange (E) and mounting ring (F).Hold in place while in...

9 • Run disposer along with a moderate to strong flow of cold water, continue run cold water for 15seconds after grinding is complete. • Avoid using hot water when grinding food waste. It is OK to drain hot water into the disposer between grinding periods. • Avoid pouring grease or fat into your dis...

10 RELEASING DISPOSER JAM This disposer is equipped with a Jam-Sensor Circuit™ thatwill prevent jams while grinding virtually any food mate-rial. In the unlikely event that the disposer is jammed,release it by following these steps. If motor stops while disposer is operating, disposer maybe jammed. ...

11 • Read all instructions before using the appliance. • To reduce the risk of injury, close supervision is required when an appliance is used near children. • Do not put fingers or hands into a waste disposer. • Turn the power switch to the off position before attempting to clear a jam, removing an...