Infinity TSS-800 - Manuals - manualsarea.com

Page 2 - ii; CAUTION; RISK OF ELECTRIC SHOCK; MPORTANT

ii TSS-800 (120V) Read First! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s ins...

Page 3 - iii; Table of Contents; WNER

iii TSS-800 (120V) ii Important Safety Precautions 1 Introduction 1 Unpacking the System 1 Planning Your System 2 Placement 2 Wall-Mounting the Satellites and Center Channel 4 Center and Satellite Speaker Connections 5 Subwoofer Controls 6 Subwoofer Connections 7 Operation 7 Maintenance and Service ...

Page 4 - Infinity Total Solutions; NPACKING THE; NTRODUCTION; LANNING

Infinity Total Solutions ™ Infinity Total Solutions continues Infinity’s longstanding commitment toaccurate sound reproduction. Our proprietary Metal Matrix Diaphragm ™ (MMD ® ) drivers, precision dividing networks and rigid, well-braced enclosures combine to deliver uncompromised performance in any...

Page 5 - LACEMENT; Using the Satellite on the Shelf Stand; ALL

2 TSS-800 (120V) Left and Right Front Channels For left and right front channels, place one satellite to the leftand another to the right of the television, as shown in Figure 1.Since the speakers are magnetically shielded, you can placethem very close to the TV without worrying about the magneticfi...

Page 7 - Turn Off All Power

4 TSS-800 (120V) C ENTER AND S ATELLITE S PEAKER C ONNECTIONS Turn Off All Power After placing the speakers, you are ready to connect your system.First, turn off all audio-system power. Use high-quality speakerwire to make your connections. #18-gauge speaker wire withpolarity coding is included. For...

Page 8 - A Few Suggestions; UBWOOFER; Rear Panel

5 TSS-800 (120V) A Few Suggestions We recommend that you do not operate your speakers orsubwoofer with the bass, treble and loudness controls set to full boost. This will place undue strain on your electronics andspeakers and could damage them. The volume control setting on your processor/preamp or ...

Page 9 - If you have a Dolby; subwoofer

6 TSS-800 (120V) S UBWOOFER C ONNECTIONS If your receiver/processor does not contain a Dolby Digital or DTS processor but has asubwoofer output: N NO OT TEE: If your receiver/processor has only one sub out, you may use either the L or R input. If you have a Dolby ® Digital or DTS ® receiver/ process...

Page 10 - PERATION; Surround Modes; Power On; Final Positioning; AINTENANCE AND

7 TSS-800 (120V) O PERATION Surround Modes When using the TSS-800 in a Dolby Digital or DTS home theatersystem, make sure all speakers are set to “Small”. In a Dolby Pro Logic ® home theater system, make sure the receiver’s center channel mode is set to “Normal.” Some Dolby Digital-equipped receiver...

Page 11 - Powered Subwoofer; PECIFICATIONS

TSS-800 Satellites Center Channel Frequency Range: 120Hz – 30kHz (±3dB) 120Hz – 30kHz (±3dB) RecommendedAmplifier Power Range: 10 – 100 Watts 10 – 125 Watts Sensitivity: 88dB 89dB (2.83V @ 1 meter) Nominal Impedance: 8 Ω 8 Ω Crossover Frequency: 3.5kHz; 12dB/Octave 3.5kHz; 12dB/Octave Midrange Drive...