iHome IP86 - Manuals - manualsarea.com

Page 2 - Table of Contents; Replacing iP86 Backup Batteries / Battery Warning; A Consumer Guide to Product Safety; Maintenance

Table of Contents Quick Start ........................................................................................................................................................................ 1 Controls and Indicators / iP86 Display ...............................................................

Page 3 - quick start; Never dock an

quick start Attach AC adaptor cable to DC jack on back of the iP86 and plug the other end into a wall socket. Snap AM antenna into provided stand, then plug antenna cableinto socket on back of iP86. Move antenna 12” away. Extend FM antenna. • Move the DST switch on back of unit to +1 or -1 (adds or ...

Page 4 - Controls and Indicators; Rear Panel

2 Controls and Indicators iP86 Display AM Loop Antenna socket AC Adaptor Jack Time Zone Button Time Sync Button DST switch Clock Adjust Button Line-in Jack Alarm Indicators Battery Low Indicator Time Display PM Indicator AM Indicator NOTE : AM/PM indicators will not appear when clock is set to 24 ho...

Page 5 - Setting Up the iP86; Connect iP86 to Power Source; Setting Time and Calendar Manually

3 Setting Up the iP86 Connect iP86 to Power Source Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120V AC wall socket. Adaptor must be plugged in to operate unit. The iP86 does not operate on batteries (a battery back up system maintains clock settings during po...

Page 6 - Using the iP86

4 Using the iP86 Reviewing, Arming and Disarming Alarm (Turn Alarm Function On and Off) 1. Once an alarm is armed, the lower part of the display will show the alarm time. If more then one alarm is armed, the earliest alarm time will show. 2. To review the alarm time, press an alarm button once. The ...

Page 7 - Using the Line-in Jack; Replacing iP86 Backup Batteries; For models that require more than one battery

5 Using the iP86 Using the Line-in Jack You can play any iPod without a docking port or other MP3 player or portable audio device through the iP86 via the Line-in Jack.1. Plug one end of a standard audio patch cord (not included) into the headphone or line-out jack on your device and the other end o...

Page 9 - Troubleshooting; Solution

iP86 does not turn on AC adaptor isn't plugged into a working wall socket or not plugged into the power supply jack on back of the unit Plug the AC adaptor into a working wall socket and plug the connector into the supply jack on the unit iP86 requires a reset If unit is plugged in and doesn't respo...

Page 11 - Solucionando problemas

Síntoma El adaptador de corriente AC no está conectado a un tomacorriente que funcione o no está conectado en la parte posterior de la unidad Conecte el adaptador de corriente a un tomacorriente que funcione y a la parte posterior de la unidad La unidad debe ser reprogramada Si la unidad está conect...

Page 12 - Síntoma

El sonido sale distorsionado El volumen se encuentra muy alto El sonido sale distorsionado de la unidad Baje el volumen Si está utilizando un iPod de primeras generaciones o un Shuffle, intente bajar el volumen de su aparato. También intente apagar el amplificador de bajos Si el sonido original de s...

Page 13 - Limited 1 Year Warranty Information

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date of original purchase.Should this product fail to function...