Ice-O-Matic VRC - Manuals - manualsarea.com

Page 3 - Page i; How To Use This Manual

Remote Condenser Introduction Page i How To Use This Manual Ice-O-Matic provides this manual as an aid to the service technician in installation and maintenance of remote condensers. Do not attempt to perform installation, start-up or maintenance unless you have read and fully understand this manual...

Page 5 - Page iii

Remote Condenser Freight Claim Procedure Page iii Freight Claims Important! Inspect Promptly This merchandise has been carefully inspected and packed in accordance with the carrier’s packing specifications. Responsibility for safe delivery has been assumed by the carrier. If loss or damage occurs, y...

Page 6 - Page

Remote Condenser Warranty Page iv Ice-O-Matic Parts and Labor Domestic & International Limited Warranty Mile High Equipment LLC (the “Company”) warrants Ice-O-Matic brand ice machines, ice dispensers, remote condensers, water filters, and ice storage bins to the end customer against defects in m...

Page 7 - Length Width

Remote Condenser General Information Page 1 Condenser Dimensions (Inches) Model Length Width Height Compatible With: VRC1001 29.18 29.50 38.90 ICE0500R4 VRC1061 29.18 29.50 38.90 ICE0605/6R4, EMF1106R2 VRC2061 29.18 29.50 38.90 ICE0805/6/R3, ICE1005/6/7R3, EMF2306R2 VRC2661 29.18 29.50 38.90 ICE1405...

Page 8 - VRC Condenser; Condenser Location; Choose a location that is protected from extremes of

Remote Condenser General Information Page 2 Introduction Ice-O-Matic Remote Condenser Systems are comprised of three components. The pre-charged remote condenser, the pre-charged ice maker and the pre-charged line set. The pre-charged line sets are available in 25, 40, 45, 60 or 75 foot line set len...

Page 9 - The; VRC

Remote Condenser General Information Page 3 The VRC remote condensers incorporate the mixing valve in the condenser. This configuration allows up to a 100 foot calculated remote line set run. Reference the diagram below to calculate the maximum 100 foot line set run. Limitations for new remote machi...

Page 10 - F air temperature at the condenser) the mixing valve opens to mix

Remote Condenser Remote Refrigeration System Page 4 The Remote Refrigeration System is shown in the above diagram. During the freezing cycle, high temperature and high pressure liquid refrigerant is directed from the condenser through a mixing valve, receiver, liquid line solenoid heat exchanger and...

Page 12 - State and Local Codes.; INSTALLATION NOTICE:

Remote Condenser Installation Page 6 Electrical Connections 1. The icemaker and the remote condenser both require a solid earth ground that meets National, State and Local Codes. 2. Reference the ice machine and condenser date plate for current requirements to determine wire size for electrical hook...

Page 13 - the legs from the condenser.

Remote Condenser Installation Page 7 Support Leg Installation-VRC 1. After removal of the packaging and fasteners, lift the condenser assembly off of the skid. 2. Locate the legs and leg braces attached to the condenser assembly. Cut the wire ties and separate the legs from the condenser. 3. Locate ...

Page 15 - vertical air flow on page 8.

Remote Condenser Installation Page 9 Proper Tubing Routing When installing the discharge and liquid lines from the remote condenser to the icemaker, please use the following guidelines: 1. The remote condenser (#2) should always be installed above the icemaker (#4) as shown with a vertical air flow ...

Page 16 - Item

Remote Condenser Service Parts Page 10 Item Description VRC1001 VRC1061 VRC2061 VRC2661 VRC5061 1 Fan Guard 9131452-01 9131452-01 9131452-01 9131452-01 9131460-01 2 Top Panel 3013222-01 3013222-01 3013222-01 3013222-01 3013303-01 3 ¼-20 x 1/2 Screw 9031019-04 9031019-04 9031019-04 9031019-04 9031019...