2 EN TABLE OF CONTENTS SAFETY RULES ������������������������������������������������������������������������������������������������������������������������������������������������������������������ 14 FIRE PROTECTION ����������������������������������������������������������������������������������...
Page 3 - INSPECTION OF POWER UNIT; RISK OF INJURY
3 EN Piping installation for a central vacuum system is not complicated. All that is required is to have a few hand tools and to read the instructions carefully. However, it is essential to do the installation carefully and safely. We recommend that you read the next few lines with the greatest atte...
Page 5 - PIPING; DANGER; CORRECT; ADHESIVE; GENERAL INSTALLATION INFORMATION
5 EN Use the following method to check the location of vacuum inlets: • Simulate cleaning each room using the hose. To do this, ask an assistant to hold the end of the hose at the point where you have assessed the inlet location. Walk around with it to cover the entire area, including the corners at...
Page 6 - INCORRECT; LOW VOLTAGE REMOTE CONTROL; COMMON COMPONENTS OF INSTALLATION KITS
6 EN WARNING! Extremely flammable.Keep away from open flame and sparks. Use only in a well ventilated area.KEEP OUT OF REACH OF CHILDREN. FIRST AID! » CONTAINS METHYLETHYLKETONE (MEK) AND CYCLOHEXANONE. » If swallowed, call a doctor or poison control center immediately. AVOID! These improper methods...
Page 7 - INSTALLING A VACUUM INLET; GENERAL INSTALLATION PROCEDURES
7 EN INSTALLING A VACUUM INLET 1� Determine the location of the vacuum inlet 2� Make sure a Short Universal Elbow can be installed at the rear of the inlet location. If the structure does not allow it, you can also use a pipe section and Ring with Stop. 3� Drill a pilot hole and make sure there are ...
Page 8 - LEAK TESTING; CLEANING AND MAINTENANCE; ADDITIONAL INFORMATION
2019-11-05 • DOC-376_EN REV02 The front face of the mounting plate must be a few millimeters inside the finished wall surface! b. Pass a piece of bent coat hanger into the inlet then into the mounting plate. Holding the mounting plate with the bent coat hanger, install the inlet using the screws pro...