Hunter 82032 - Manuals - manualsarea.com

Page 2 - minimum of 3 feet from the tub or shower opening. See Figure A.; W A; Continued; Bath Fan; Figure A

2 42935-0 06/04/2007 ) Read all instructions before attempting to install or use this appliance. This appliance is for general ventilating use only. Do not use this appliance for ventilating hazardous or explosive materials. Follow the heating equipment manufacturer’s guideline and safety standards,...

Page 4 - Before Installation

42935-0 06/04/2007 4 F G H I L M x2 N x3 * * A B C 95044-01-000 97128-01-000 03242-07-133 97118-01-000 x2 D 97517-01-000 74508-03-133 Mounting Rails Housing Wiring Cover Fan Assembly 3/8” Cable Connector Bezel Wiring Cover Screw Check all the parts. If damaged, call 1-888-830-1326 for replacement. x...

Page 5 - Choose Installation Option

42935-0 06/04/2007 5 Loosen the wiring cover screw. Remove the fan assembly from the housing. Remove the wiring cover. D E C Choose Installation Option For New Construction - attaching to joist, go to step A, page 5. For New Construction - suspended between, joists go to step B, page 7. For Existing...

Page 6 - New Construction - attaching to joist; OR

42935-0 06/04/2007 6 A1 Section A - New Construction - attaching to joist Drive mounting screws (supplied) into joist or framing. position the correct depth mark at the bottom edge of the joist based upon the the thickness of your sheetrock. 5/81/2 5/81/2 A2 pop out a wiring access slug. OR Install ...

Page 7 - Section B - New Construction – suspended between joists

42935-0 06/04/2007 7 A6 Connect 4” duct and vent to the outside. Use duct tape to secure joints. If ducting does not fit securely, an adapter may need to be purchased. Go to Section E - Final Installation on page 14. Section B - New Construction – suspended between joists pop out a wiring access slu...

Page 9 - Section C - Existing Construction – accessible from above; NO EXISTING FAN

42935-0 06/04/2007 9 B10 Install the wiring and the strain relief into the wiring access hole you made earlier. B11 Connect 4” duct and vent to the outside. Use duct tape to secure joints. If ducting does not fit securely, an adapter may need to be purchased. Go to Section E - Final Installation on ...

Page 12 - Section D - Existing Construction – accessible from below; EXISTING FAN

42935-0 06/04/2007 2 Go to Section E - Final Installation on page 14. Section D - Existing Construction – accessible from below Remove one of the wiring access slugs on the top of the housing. Use a second wiring access plug if needed. EXISTING FAN D3 Remove an existing fan and check to make sure th...

Page 14 - Section E - Final Installation

42935-0 06/04/2007 4 E2 E3 Connect fan wiring harness. DO NOT ALLOW THE FAN TO HANG FROM THE WIRING HARNESS. Install the wiring cover box. Make sure all wiring connec- tions are inside the wiring cover box. Section E - Final Installation NOTE: Though this final installation section shows the housing...

Page 17 - Warranty

7 42935-0 06/04/2007 Hunter Fan Company Bath Fan LIMITED WARRANTY Hunter Fan Company makes the following limited warranty to the original user or consumer purchaser of this Hunter Bath Fan: If any part of your Hunter Bath Fan fails at any time within one year after the date of sale to you due to a d...