Hoover Plus- Manuals

Page 2 - Save these instru c t i o n s !; Fill in and Retain; Index; I m p o rtant Safeguard s !

• Use indoors only.• Use only on surfaces moistened by the cleaning process or small spills. Do not immerse product. • Connect to a properly grounded outlet only. See “Grounding Instructions”.• Do not clean over floor electrical outlets.• Do not use without tanks in place.• Use extra care when clean...

Page 3 - Included with some models

3 GroundingInstructions This appliance must be grounded. If itshould malfunction or breakdown,grounding provides a path of least resis-tance for electrical cur rent to reduce therisk of electric shock. This appliance isequipped with a cord having an equip-ment-grounding conductor (C) andgrounding pl...

Page 4 - Attach upper handle; Attach hose holder; Attach tool holder; Assemble handle

Press cord into cord clip on back ofhandle. Pull cord tight. 4 The assembled cleaner will look like thisdrawing (Plus model shown). 1-2 Attach upper handle Remove clean solution tank (upper tank)from deep cleaner. With cord hook (A) to back of deep cleaner,push upper handle down onto lower han-dle. ...

Page 5 - For Plus models; Deep cleaner description; *Included with some models; Continued

5 1 - 1 0 1 -1 3 1 - 1 5 Slide rack down into place. Insert screwat (D) and tighten with a Phillips screw-driver. Storing hose & tools Store hose on rack by first positioninghose in front section of holder. D Continue wrapping hose under lowerhook (E). Snap hose end fully into hold- er (F). The ...

Page 7 - The tanks; How to fill; Recovery tank

7 2-10 The tanks Clean solution tank (upper tank) The clean solution tank holds the clean-ing solution that is to be dispersed ontothe surface to be cleaned. How to fill Disconnect deep cleaner from electrical outlet. Place deep cleaner handle in theupright, locked position. To remove tank, press do...

Page 8 - After cleaning

8 2-17 2-18 Raise handle to car rying position(straight up) to unlock tank from base of deep cleaner. Lift tank from deep clean -er and car ry it to a sink or drain. To remove tank lid, lower handle com-pletely toward back of tank and lift offlid. Empty the tank and reposition the lid. 3-1 UNLOCK Fo...

Page 9 - Carpet Cleaning; Using the tools; How to attach tool

9 Continued ➜ Your HOOVER SteamVac deep cleanermay also be used to pick up small liq- uid spills (1 gallon or less, never toexceed 1/4 inch in depth) on carpet, upholstery, or bare floors. For best results, pick up spills immedi-ately by placing the stair/upholstery noz-zle just above the spill and ...

Page 10 - Cleaning upholstery

10 7. Pre-spray the carpeted stair by hold-ing the tool about one inch above thecarpet and push it forward while press-ing the trigger (equals one wet stroke). 8. Position tool against the riser and slightlyp ress it into carpet pile. Press the triggerand pull the tool s l o w l y over the carpet ( ...

Page 11 - To remove bru s h e s; S t o r a g e

11 Lubrication The motor Is equipped with bearingswhich contain sufficient lubrication forthe life of the motor. The addition oflubricant could cause damage. Do not add lubricant to motor bearings. Service To obtain approved HOOVER serviceand genuine HOOVER parts, locate thenearest Hoover Factory Se...

Page 12 - Full Six Month

• Blown fuse/tripped breaker• Replace fuse/reset breaker 5. If you have aproblem Problem: Machine won’t run Problem: Low suction Problem: Clean solution won’t dispense Problem: Brushes/brush indicator won’t rotate during floor cleaning Possible cause Possible solution • Recovery tank full/automatic ...