Hoover FloorMAX Supreme- Manuals

Page 2 - IMPORTANT SAFEGUARDS!; SAVE THESE INSTRUCTIONS!

2 Fill in and retain The model and serial number are located on the rear wheel cover of floor machine. For your personal records, please enter the COMPLETE model and serial numberin the spaces provided and retain this information. Your floor machine is model and has serial number It is suggested tha...

Page 3 - Carton contents; Questions or Concerns?; Description

G 1. Assembly Carton contents Unpack the floor machine and identify the accessories shown. Remove anddispose of the packing. A. Floor Machine and Upper Handle B. Shampoo Brushes C. Power Scrub and Cleaning Brushes D. Felt Buffing Pads (gray) E. Heavy Duty Cleaning and Waxing Pads (yellow) F. Soft Cl...

Page 4 - Attaching tank; Connect handle; Polarized plug

4 Remove tank from shampoo-polisher andremove nut, bolt and cord clip from topof lower handle section. 1-3 1-4 Join upper and lower handles, lining upholes. Place cord clip around cord withflat side toward handle and holes tofront. 2. How to use ON-OFF switch The floor machine’s ON-OFF switch isinte...

Page 5 - Cleaning floors

5 Dispensing solution Squeeze trigger to dispense cleaningsolution onto carpet, rug or floor. 2-6 2-7 2-8 Removing tank Turn tank cap lock until the rivet isdirectly above slot. Lift up lock and tank cap. Pull top of tank forward; Iift tank fromfloor machine. Cleaning floors There are three methods ...

Page 6 - Waxing floors

6 Waxing floors There are two types of wax to use on hard surface floors: water-base and sol -vent-base. 1. Water-base wax Water-base wax is a self-polishing waxwhich does not contain a petroleum sol-vent. It can be used on all hard surfacefloors except wood. Follow the directions on the container t...

Page 7 - Before you begin; Test for colorfastness

7 Before you begin 1. Test for colorfastness Apply some HOOVER Rug and CarpetShampoo solution (shampoo mixed withwater according to directions on the shampoo container) or a dry foam to asmall inconspicuous area of the carpetand rub with a white cloth. Check to seethat color does not come off on the...

Page 8 - Allow carpet to dry; Splash guard

8 3. Maintenance 3-1 2 - 1 5 Crisscross area to work foam uniformlyinto the carpet (see illustration) until thefoam disappears. The final strokes overeach area should always be in the samedirection. Repeat the process over another 3 ft. x3 ft. area (1m x 1m), overlapping theareas by several inches. ...

Page 9 - Service; Lubrication; Storage; Problem: Floor machine won’t run; problem

9 Service To obtain approved HOOVER serviceand genuine HOOVER parts, locate thenearest Hoover Factory Service Center or Authorized Hoover WarrantyService Dealer (Depot) by: • checking the Yellow Pages under “Vacuum Cleaners - Household” OR - • checking the list of Factory Service Centers provided wi...

Page 10 - Floor care hints; Problem: Slippery floor; Accessories

10 Floor care hints Floors may be difficult to care forwhen not treated properly. Refer tothe chart below for solutions to floorproblems. Problem: Slippery floor Problem: Streaked floor Problem: Dull floor Problem: Scratched floor Po s s i ble cause Possible solution • Too mu ch wax.• Remove wax. Ap...