Hoover 53441 - Manuals - manualsarea.com

Page 2 - Fill; Index

Fill ! The HOOVER commercial upright cleaner you have just purchased is for carpet and rug cleaning. The cleaning tool attachments are for floor cleaningand above the floor cleaning. Your cleaner is a model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Page 4 - UNPACKING THE

UNPACKING THE Unpack the cleaner from the carton and identify the parts shown in Fig. 1. Remove and dispose of the cardboard I packing. 1. Upper handle section 2. Lower handle section 3. Cleaner base 4. Cloth bag assembly The cleaner assembled will look like the drawing below. FIG. 1 l . After ident...

Page 9 - CLEANING TOOL ATTACHMENTS; USING CLEANING TOOLS

CLEANING TOOL ATTACHMENTS Cleaning tools are available at additional cost from Hoover Dealers. The clean-ing tools allow you to do above the floor cleaning and to clean hard to reach areas. Deluxe cleaning set Includes vinyl hose with suction regulator and con-verter, curved wand, straight wand, dus...

Page 11 - the proper cleaning; C. Attaching the tools

the proper cleaning The cleaning tools have many uses. Select the tool best suited for thecleaning task from the descriptions below. Wall/floor brush* For walls and very irregular hard surface floors such as brick and slate. Fig. 1. Furniture nozzle* For upholstered fur- niture, draperies, tapestrie...

Page 12 - D. Regulating the suction

Turn the plastic ring counterclock- wise to lock the tool in place. Fig. 8. For additional length, attach one or both* wands to the vinyl hose as scribed above. To attach the tools to the other end of the wand, press down firmly onthe white plastic spring latch. Fig. 9. Fit the attachment into place...

Page 13 - Storing attachments; MAINTENANCE

Storing attachments For Storage, the attachment set will conveniently fit in the storage bag.* The bag has two slots located near the top for use in hanging. Therefore, it can be attached to the cleaner or hung conveniently on a hook in the closet. To clean attachments To clean the hose wipe off dir...

Page 15 - the agitator roll there is a raised metal; belt; nearer cleaner should be in line with

2. Release worn belt from pulley. 3. Lift out rug agitator, remove oldbelt and place new belt in groove ofrug agitator. 4. Replace agitator. On one end of the agitator roll there is a raised metal plate. Make sure that this end isplaced in groove on side of cleaner. 5. Place belt on pulley. Side of ...

Page 16 - What brushes to buy

The brushes When to replace brushes When brushes are worn and bristles do not touch the edge of a card held across the bottom plate, they should be replaced. Always replace both brushes at the same time to maintain cleaning effectiveness. What brushes to buy When purchasing new brushes, ask for Hoov...

Page 18 - USER CHECK LIST; check list is provided for your convenience.

USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usuallycan be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience. Problem P...

Page 19 - ENERGY SAVING TIPS; ‘3. Turn off cleaner when not in use, such as when moving furniture.

ENERGY SAVING TIPS 1. Empty cleaner bag promptly, before overfilled. 2. To maintain effective cleaning, replace agitator brushes and belt when necessary. ‘3. Turn off cleaner when not in use, such as when moving furniture. 4. Keep your cleaner operating at peak performance level have inspection and ...

Page 20 - VCMA

VCMA VACUUM CLEANER MANUFACTURERS ASSOCIATION (HOOVER -AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned product safety. These basic guidelines are for your p...