Hoover 53425- Manuals

the proper cleaning The cleaning tools have many uses. Select the tool best suited for thecleaning task from the descriptions below. Wall/floor brush* For walls and very irregular hard surface floors such as brick and slate. Fig. 1. Furniture nozzle* For upholstered fur- niture, draperies, tapestrie...

Turn the plastic ring counterclock- wise to lock the tool in place. Fig. 8. For additional length, attach one or both* wands to the vinyl hose as scribed above. To attach the tools to the other end of the wand, press down firmly onthe white plastic spring latch. Fig. 9. Fit the attachment into place...

Storing attachments For Storage, the attachment set will conveniently fit in the storage bag.* The bag has two slots located near the top for use in hanging. Therefore, it can be attached to the cleaner or hung conveniently on a hook in the closet. To clean attachments To clean the hose wipe off dir...

2. Release worn belt from pulley. 3. Lift out rug agitator, remove oldbelt and place new belt in groove ofrug agitator. 4. Replace agitator. On one end of the agitator roll there is a raised metal plate. Make sure that this end isplaced in groove on side of cleaner. 5. Place belt on pulley. Side of ...

The brushes When to replace brushes When brushes are worn and bristles do not touch the edge of a card held across the bottom plate, they should be replaced. Always replace both brushes at the same time to maintain cleaning effectiveness. What brushes to buy When purchasing new brushes, ask for Hoov...

USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usuallycan be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience. Problem P...

ENERGY SAVING TIPS 1. Empty cleaner bag promptly, before overfilled. 2. To maintain effective cleaning, replace agitator brushes and belt when necessary. ‘3. Turn off cleaner when not in use, such as when moving furniture. 4. Keep your cleaner operating at peak performance level have inspection and ...

VCMA VACUUM CLEANER MANUFACTURERS ASSOCIATION (HOOVER -AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned product safety. These basic guidelines are for your p...

5 paper bag Align opening in paper bag with dirttube (S) inside bag compartment. Push paper bag firmly onto tube. Tuck top and bottom of paper bag into bag compartment. To replace bag door, insert the 2 tabs on bottom of bag door into the 2 slotson bag compartment. Make sure all edges of paper bag a...

description 1 6 Operate cleaner only at voltage specified on data plate on bottom of cleaner. This cleaner is intended for household use. The assembled cleaner will look like the drawing. 1. 2. switch 3. Cord hooks: wrap cord around hooks for storage. The top hook canbe rotated right or left for eas...

height adjust- For ease in sliding the control, the han- dle should be in the upright position. When it is necessary to raise and lower the front of the- cleaner (A) for various carpet pile heights, slide the carpet height control(3) to the correct setting. The front of the cleaner will not move int...

B. Select proper clean- Attach wand and ing tool A. Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, Venetian blinds, baseboards, shutters, and registers. B. Furniture nozzle may be used for upholstered furniture, draperies, tapestries, mattresses, automob...

Belt. The -belt on your cleaner causes the agitator to rotate- and isimportant-for the effective operation of the cleaner.- The is located under the bottom-plate of the cleaner andshould be checked from time to time to be sure it is in good condition. When to replace L To check belt, remove bottom p...

Edge groomer Lubrication replacement When to replace The edge groomers, located on both sides of the front of the cleaner, shouldbe replaced when they no longer extendpast the surface of the bottom plate. What to buy When purchasing edge groomers, ask for HOOVER part No. 39511004. Replacing edge gro...

Clearing blockages Remove large items from surfaces beforevacuuming to prevent blockages and to maintain cleaning effectiveness of yourcleaner. Refer to the following steps to check blockages continuing with each step until the blockage is found. A. a blockage occurs during tool use: Turn cleaner OF...