Hoover 53391 - Manuals

Cleaner description 1. 2. 3. 4. 5. 6. 7. a.9. Cover: remove by lifting up top section of carrying handle and pulling forward. Carrying handle Check bag indicator: shows red when paper bag should be checked for fullness. Extension wands: use with power nozzle. If added length is desired when using cl...

Questions or Concerns? Hoover Company wants to quickly resolve any concerns about your cleaner or questions regarding its use. Look on the list provided with the product for your local Hoover Factory Service Center or in the Yellow Pages under “Vacuum Cleaners Household” for the nearest Authorized H...

How to use To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician t...

Suction regulator The suction regulator is located on the hand grip and is used to increase or decrease suction for various cleaning tasks. If the power nozzle is difficult topush on some carpet, open the suction regulator. This will prevent damage to the belt. Cleaning tools The cleaning tools have...

To connect and remove tools To connect tools, insert end of tool into extension wand and snap intoposition. To disconnect, press down on the center of the spring latch and remove tool. Tools attach to hand grip by rotating plastic ring until slots in the opening align. Insert tool and turn latch rin...

How to store Your cleaner can be stored on end as shown in the illustration. Store power nozzle with handle inupright position. The hose and extension wands can be stored disassembled from the cleaner if desired. Maintenance The following sections are concerned with proper maintenance of the cleaner...

How to replace Disconnect cleaner from electrical outlet. Remove cover by lifting top section of carrying handle and pulling forward. 3. Place lower notched edge ofnew bag collar into grooves located inside front of cleaner. 2. Depress latch and lift out used bag. 4. Pull collar forward until latchs...

Obstructions Remove larger items from carpet and floor surfaces before vacuuming tohelp prevent obstructions in hose, wands or nozzle connector, and to maintain cleaning effectiveness of your cleaner. There are two conditions that will indicate that an obstruction has occurred: Cleaner stops running...

How to clean Disconnect cleaner from eiectri- cai outlet. The secondary filter is located inside the cleaner behind the paper bag. To remove filter, first remove cover of cleaner, then lift out filter. Clean filter by rinsing it in water. When dry, slide filter back into position. Do not operate cle...

6. Position nozzle cover on front lip of nozzle base. Press cover into place. Turn nozzle over and replace screws. The agitator When to replace Disconnect cleaner cai outlet. When agitator brushes are worn,the agitator should be replaced. To check condition of brushes, move the edge of a card across...

Lubrication The motor is equipped with bearings, which have been lubricated for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. The agitator is equipped with two ball bearings that should be lubricated periodically by a Ho...

Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: checking the Yellow Pages under “Vacuum Cleaners Household” OR checking the list of Factory Service Centers provided with this...