Page 3 - Important Safety Notice; • DO NOT; To reduce the risk of fire, electric shock, or injury to persons:; DO NOT; To reduce the risk of a stove top grease fire:
Important Safety Notice Read all Instructions before Installing and operating this appliance • The installation in this manual is intended for qualified installers, service technicians or persons with similar qualified background. Installation and electrical wiring must be done by qualified professi...
Page 4 - WARNING; what can happen if the instructions are not followed.; To reduce the risk of injury to persons in the event of a gas leaks:
Page 2 Important Safety Notice Read all Instructions before Installing and operating this appliance WARNING Your safety and the safety of others is very important. We have provided many important safety mes - sages in this manual and on your appliance. Always read and obey all safety messages. All s...
Page 5 - Table of Contents; INSTALLATION
Table of Contents INSTALLATION Tools needed....................................................3 Parts supplied...................................................4 Venting requirements.......................................5 Mount heights & clearance...........................5-6 Calculating ven...
Page 7 - Venting Requirements; For the most efficient & quiet operation:
Ceiling Height Venting Requirements Page 5 Height & Clearance Under Cabinet Range hood 36” Counter Top Min: 27” Max: 30” • Vent system must terminate to the outside (roof or side wall). • DO NOT terminate the vent system in an at - tic or other enclosed area. • DO NOT use 4” (10.2 cm) laundry-ty...
Page 8 - Duct Run Calculation:; Calculating Vent System Length
Page 6 IMPORTANT: • A minimum of 8” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate - ly) must be used to maintain maximum airflow efficiency. • Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided duct. • Pl...
Page 9 - Venting Methods; Vertical roof venting; Horizontal wall venting
Venting Methods Page 7 • This range hood is factory set for venting through the roof or wall. • Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. IMPORTANT: • NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceili...
Page 10 - Electrical Requirements
IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualified electrician for 220-Volt 50 Hz voltage)It is the customer’s responsibility: • To contact a qualified electrical installer. • To assure that the electrical installation is adequate and in conformance with National...
Page 11 - Preparation; Advanced Preparations:; Excessive Weight
Page 9 Figure 1 Figure 2 Preparation Advanced Preparations: • Be familiar with the controls of the range hood by reading through Range Hood Operations , Page 12. • Place the range hood on a flat, stable surface. Connect the range hood to a designated standard outlet (please refer the product label f...
Page 12 - Installation
Page 10 Installation Figure 3 Figure 5 Figure 4 Installations (refer to Page 4 for parts) : Measure the distance between stove top and the bottom of range hood. A distance of 27” to 30” is recommended*. *Due to different ceiling height configurations, recom - mended height may not be applicable. 1. ...
Page 14 - Range Hood Operations; Control Panel Layout and Buttons Configurations:
Page 12 Range Hood Operations Control Panel Layout and Buttons Configurations: In addition to the remote control feature, this range hood is also equipped with a heat sensor that will self-calibrate in 5 seconds when the range hood is first electrically activated and beeps when self-calibration is d...
Page 15 - CAUTION: DO NOT touch the lights until switched OFF and cooled.
Page 13 Range Hood Operations (Continued) Control Panel Layout and Buttons Configurations: Activating Light Function: • Press Light button once to turn on the lights, and once again to turn off the lights. CAUTION: DO NOT touch the lights until switched OFF and cooled. Activating Power-Off Delay Fun...
Page 16 - Troubleshooting
Troubleshooting Page 14 1. If the range hood or halogen light does not operate after installation: • Check if the range hood has been plugged in, make sure that all power has been turned back ON, fused not blown and all electrical wiring are properly con - nected. • Swap out light assembly to workin...
Page 17 - Use and Care Information; Specifications
Use and Care Information Operations: • Read and understand all instructions and warnings in this manual before operating the appliance. Save these instructions for future reference. • Always leave safety grills and filters in place. Without these components, operating blowers could catch on to hair,...
Page 18 - Measurements and Diagrams
Measurements and Diagrams • All measurements in parenthesis are in millimeter. • All inch measurements are converted from millimeters, thus inch measurements are estimated. Page 16 Overall (PS37): Overall (PS13/PS15):
Page 24 - Maintenance
Page 22 Maintenance SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating! help preserve the appearance of the range hood. Cleaning Exterior surfaces: • Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent (e.g....
Page 25 - Warranty
Page 23 One Year Parts Warranty: For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replace- ment parts or components that failed due to manufacturing defects. Subject to the conditions and limitations set forth below, your local reseller...
Page 26 - Contact Us
Page 24 Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and signature of the carrier’s agent and keep copy to support your claim. Upon a claim immediately. Failure to do so may result in the denial of your claim...
Page 27 - Your Notes
Page 28 - Menands
