Hobart ML-104562 6460C - Manuals

Page 2 - Installation, Operation and Care of; SAVE THESE INSTRUCTIONS; GENERAL

– 2 – Installation, Operation and Care of MODEL 6430, 6430T, 6460 & 6460T PEELERS SAVE THESE INSTRUCTIONS GENERAL Models 6430 and 6430T Peelers are designed to peel 30 to 33 lbs (13.5 to 15.0 kg) of product in 1 to3 minutes using a 3 / 4 HP, single- or three-phase electric motor. The 6430T inclu...

Page 4 - LEXAN LINER; Secure the keeper using the exterior latch.; PEEL TRAP

– 4 – LEXAN LINER 1. Slide the liner (Fig. 2) into the hopper, ensure the liner is under retaining brackets (Fig. 2) and resting on the top of the lip (Fig. 2) on the bottom of the hopper chamber. PL-41652-1 LINER RETAINING BRACKETS LIP PL-41653 KEEPER Fig. 2 Fig. 3 2. Push the liner keeper into the...

Page 5 - Assemble a leg and a leg slot cover on the leg clamp bolt.; Peelers; If desired, the peel trap legs may be bolted to the floor.

– 5 – Assemble the legs as follows (Fig. 4): 1. Lay the peel trap on its side. 2. Assemble one of the rubber gaskets to one of the curved leg clamp bolts. 3. Assemble the bolt and gasket from the inside, through one of the leg bolt holes in the peeler housing. 4. Assemble a leg and a leg slot cover ...

Page 7 - If desired, the disposer stand feet may be bolted to the floor.; PLUMBING; Connect a cold water supply to the; Peeler Unit With Disposer; Connect a cold water supply line to the fill valve, which has a

– 7 – DISPOSER STAND If a disposer stand is to be used, unpack the stand from its shipping carton. The feet may be threadedin or out as necessary to level the disposer stand. The disposer flange, adapter plate, gaskets and all hardware required for mounting the disposer areassembled and packed in a ...

Page 8 - ELECTRICAL CONNECTIONS; ELECTRICAL AND GROUNDING CONNECTIONS MUST; BRANCH CIRCUIT SIZE AND PROTECTION

– 8 – ELECTRICAL CONNECTIONS Before making electrical connections, check the specifications on peeler data plate (Fig 1), as well as those of the disposer (where applicable), to assure they agree with those of your electrical service. WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH TH...

Page 9 - OPERATION; clockwise into place.; CLEANING

– 9 – OPERATION Using the lugs on the hopper top as locators, position the hopper top on the housing and turn it clockwise into place. Close and latch the discharge chute door. Pour the product into the hopper. There should be room in the hopper for the product to move around while peeling. Do NOT o...

Page 10 - MOTOR; MAINTENANCE; LUBRICATION

– 10 – Turn on the water or disposer, if equipped, and thoroughly clean the interior of the hopper using a mildsoap and brush. Turn off the water or disposer. If the drawer is equipped with a peel trap, remove the peel trap drawer and thoroughly clean the drawer,as well as the peel trap interior. Th...

Page 11 - TROUBLESHOOTING; SYMPTOM; Electrical power not connected.; SERVICE

– 11 – TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE Peeler won't operate. Electrical power not connected. Circuit breaker tripped or fuse blown. Excessive foaming. Too much water in the hopper. If the above suggestions do not remedy the situation, contact Hobart Service Office. SERVICE Contact your local ...

Page 15 - NOTES