Hobart HM1200 - Manuals - manualsarea.com

Page 2 - IMPORTANT SAFETY INSTRUCTIONS

– 2 – IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions must be followed, including the following: WARNING: TO REDUCE THE RISK OF BURNS, ELECTRIC SHOCK, FIRE, INJURY TO PERSONSOR EXPOSURE TO EXCESSIVE MICROWAVE ENERGY: 1. Do not use metal utensils in this oven....

Page 3 - CAUTIONS; Do NOT use newspapers or paper bags for cooking.

– 3 – PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY 1. Do not attempt to operate this oven with the door open since open-door operation can result in harmful exposure to microwave energy. It is important not to defeat or tamper with the safetyinterlocks. 2. Do not place any ob...

Page 4 - SAVE THESE INSTRUCTIONS; GENERAL; Microwaves penetrate the food to a depth of about; RADIO INTERFERENCE; INSTALLATION; U N P A C K I N G

– 4 – Installation, Operation and Care of MODEL HM1200 MICROWAVE OVEN SAVE THESE INSTRUCTIONS GENERAL Microwave heat is generated inside the food rather than being conducted through the food as inconventional methods. Time is used to control the amount of heating that occurs. Microwave energy is abs...

Page 5 - Ignore this section if only installing one oven.; SEAL OVEN BASE TO COUNTERTOP

– 5 – LOCATION Place the oven on a suitable countertop, shelf or table with a smooth, flat and stable surface. Do notplace the oven in a hot or damp area, near a gas or electric range. The microwave oven must not belocated above or next to sources of excessive heat or greasy air. Clean air must be f...

Page 7 - OPERATION; Model HM1200 Microwave Oven; DISPLAY AND KEYPAD

– 7 – OPERATION Model HM1200 Microwave Oven DISPLAY AND KEYPAD Memory Keys are preset at the factory to HIGH power level and single stage cooking for these times: Refer to PROGRAMMING MEMORY (pages 9 – 10) to program Memory Keys to other times. Refer to PROG LOCK and PROG UNLOCK (page 12) to Lock or...

Page 8 - MANUAL HEATING; Place the food in a suitable container inside the oven.; Turn the TIMER DIAL until the desired time displays.; To resume cooking, close the door and press START; * This assumes that the beep tone duration was not changed.

– 8 – MANUAL HEATING When the oven is connected, a beep sounds. The display remains idle (blank) until you open the doorand [ 0 ] displays for 1 minute. While [ 0 ] is displayed, the Memory keys or the Power Level key andTimer Dial allow the time and power level to be set for a cooking cycle. Manual...

Page 10 - NOTES

– 10 – Custom Programming the X 2 Key for Multiple Portions The oven must be set on Program Unlock to perform functions on this page (refer to page 12). a. Keep the door closed. Make sure the Display is blank. b. While pressing the START key, press the POWER LEVEL key. [ PROG ] blinks in the Display...

Page 11 - COOKING USING A PROGRAMMED MEMORY KEY AND THE

– 11 – COOKING USING A PROGRAMMED MEMORY KEY AND THE X 2 (DOUBLE PORTION) KEY This example shows how the oven runs after a Memory key has been programmed for 14 minutes atHIGH (refer to pages 8 – 9). This example requires that a large amount of food be placed in the oven. 1. Open the door; [ 0 ] dis...

Page 13 - PROGRAMMING BEEP TONE: LOUDNESS; PROGRAMMING BEEP TONE: DURATION

– 13 – PROGRAMMING BEEP TONE: LOUDNESS Beep Tone Loudness can have one of the following settings: 3 Loud, 2 Moderate, 1 Soft, 0 Silent. 1. Open the door and leave it open. 2. While pressing START, press POWER LEVEL. 3. The Display has the 1 above STAGE . Press Memory key 1 the number of times necess...

Page 15 - Wash the Air Filter in warm soapy water. Allow to dry.; CLEANING THE SPATTER SHIELD

– 15 – CLEANING WARNING: UNPLUG ELECTRICAL POWER CORD BEFORE PERFORMING ANY CLEANING ORMAINTENANCE. Keep the inside of the oven clean. If pieces of food or spilled liquids stick to the oven walls or betweenthe door seal and door surface, they will absorb microwaves and may cause arcing or sparks. Wi...

Page 16 - MAINTENANCE; REPLACING THE CAVITY LIGHT BULB; If the Cavity Light Bulb burns out, you can replace it yourself.; TROUBLESHOOTING; SERVICE; li

– 16 – MAINTENANCE REPLACING THE CAVITY LIGHT BULB If the Cavity Light Bulb burns out, you can replace it yourself. WARNING: UNPLUG ELECTRICAL POWER CORD BEFOREPERFORMING ANY CLEANING OR MAINTENANCE. • Unscrew the screw on the Cavity Light Cover located on the leftside of the cabinet (Fig. 7). • Rep...