Hitachi KH-186B - Manuals - manualsarea.com

Page 5 - Safety precautions; English

-1- Safety precautions Precautions described here are intended for safe and correct use of this product and are to prevent injury and damage to you and others before they occur. Precautions are classified as follows. Make sure to observe the precautions because they are all important in relation to ...

Page 8 - Preparation before use

-4- Level indicator lampLOW (green): MEDIUM (green): HIGH (red)When the power switch is switched to “On,” the lamp indicating “Low” is turned on. This lamp is not turned on in “Cool” mode. Level switch buttonEvery time the button is pressed, "the strength" of the electrical potential will ch...

Page 10 - Example for use; How to use

-6- Example for use Step 2 "HOT MOISTURIZE" When you do not have much time in the morning or when you need to go out suddenly, you can just use “HOT MOISTURIZE.” It only takes approximate three minutes to moisturize your skin thoroughly. Press the mode switch button to set to “HOT MOISTURIZE...

Page 11 - Step 1

-7- 2 After confirming that the power adaptor is connected to the main body, press the power switch. (Fig. 4) 3 Choose "the strength" of electrical potential with the level switch button. Switch the "strength" with the level switch button according to the condition of your skin. ● ● ...

Page 12 - Step 2; When using cotton

-8- ● ● ● 8 Remove the ring and the cotton. 6 After 3 minutes have elapsed, the device will automatically shut off. (Auto shutoff function) The finishing sound (beep beep) will inform you. ● ● Wipe off the surface of the heating head with a tissue.Do not use the cotton again once it is used. It migh...

Page 13 - When not using cotton

-9- 8 After use, make sure to pull out the power adaptor from the electric outlet and the main body. (Fig. 7) To continue to use the next mode, do not disconnect the power adaptor. ● ● 3 Choose "the strength" of electrical potential with the level switch button. Switch the "strength"...

Page 16 - About skin sensing function

-12- ● 1 After confirming that the power adaptor is connected to the main body, press the power switch. (Fig.11) “Low” on the level indicator lamp lights and “ COOL ” on the mode indicator lamp starts flashing. If a lamp in another mode is flashing, press the mode switch button to switch to “ COOL ....

Page 17 - Care for main body; How to preserve

-13- ● ● ● ● Wipe off the toner on the head and the body with a tissue.When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and wring it thoroughly. Care for main body ★ Do not use alcohol, benzine, or thinner. (Cause of deformation or discoloration) CAUTION How ...

Page 18 - CAUTION

-14- CAUTION Make sure to pull out the device plug from the main body after using.Do not store it when the power adaptor is connected with the main body or the cord is wound around the main body. (Result in damage of the cord) Cord Do not wind the cord around the main body. Device plug. ※ Make sure...

Page 19 - NOTICE; About Skin Testing Function; The cotton puff does not contain enough toner.; The actual operating time normally would be longer.; Attention for Use; About Auto-off Function

-15- NOTICE About Skin Testing Function About Operating Time The continuous operating time of each mode is default.The time is not included under below circumstances: When the head or the head attached with cotton puff and back plate are not contacted with skin continuously. The cotton puff does n...

Page 20 - FAQs; Questions

-16- FAQs No. Questions Answers Q1 Tingling sensation is felt on the skin. ・ Check the intensity level. If it is set on "High" level, press the level switch button to switch to "Low" level. ・ If toner in the cotton pad wears off, replenish it again. ※ If you still feel uncomfort...