Hitachi 32LD6600 - Manuals

- 5 - Preparation For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault and unsafe situations, please do not place any objects on top of the set.Use this apparatus in tropical and/or moder- ate climates. Features • Remote controlled colour television.• 100 pr...

- 7 - "The LCD panel is very high technology product with about a million thin film tran- sistors, giving you fine picture details. Oc- casionally, a few non-active pixels may ap- pear on the screen as a fixed point of blue, green or red. Please note that this does not affect the performance of ...

- 8 - Before Switching On Your TV Power Connection IMPORTANT: The TV set is designed to op- erate on 220-240V AC, 50 Hz. • After unpacking, allow the TV set to reach the ambient room temperature before you con- nect the set to the mains. Connections To The Aerial Input Socket 9+)8+) : 5($52)7+(79 &a...

- 9 - Unplug the power cord from the mains socket. Initial Settings Initial APS (Automatic Programming System) The following menu will be displayed on the screen when you turn your TV on for the first time. APS, searches and sorts all channels and stores them automatically on your TV, a c c o r d i ...

- 10 - • Press the “P+” button to select the next programme. Programme Selecting (direct access): Press digit buttons on the remote control handset to select programmes between 0 and 9. The TV will switch to the selected programme after a short delay.• For a two digit programme number enter the seco...

- 11 - Film Mode Films are recorded at a different number of frames per second to normal television programmes.By pressing a / b button, select Film Mode. Press _ / ` button to set this feature On or Off. Turn this feature on when you are watch- ing films to see the fast motion scenes clearly. 3D Co...

- 12 - Sound Mode By pressing a / b button, select Sound Mode. Press _ / ` button to change the mode.You can select Mono , Stereo, Dual A or Dual B mode, only if the selected channel sup- ports that mode.In case of bilingual broadcast (Dual Sound), you can select original or dubbed language using mo...

- 13 - Ext-2 Out By pressing a / b button, select Ext-2 Out. You can set Ext-2 Out to TV, EXT-1, EXT-3, EXT-4, EXT-5 or PC by pressing _ / ` button. Note: Only audio output is available for EXT- 3, EXT-5 and PC. The other options have both audio and video outputs. Default Zoom By pressing a / b butt...

- 14 - found. You can also enter a frequency value directly by pressing the digit buttons. VCR (Video Cassette Recorder) • This item can be seen in all modes except EXT-3, EXT-5 and PC. • If you want to watch a VCR source from one of these modes, then it will be better to set VCR mode “on”. For this...

- 15 - Source menu By pressing _ / ` button, select the sixth icon. Source menu appears on the screen. 79 6285&(79 (;7(;7(;7(;7 (;76(;7 3& In source menu, highlight a source by pressing a / b button and switch to that mode by pressing _ / ` or “ OK ”button. PC Mode Installation • Power off b...

- 16 - • Use _ / ` button to adjust the value. Phase Depending on the resolution and scan fre- quency that you input to the TV Set, you may see a hazy or noisy picture on the screen. In such a case you can use this item to get a clear picture by trial and error method.• Use _ / ` button to adjust th...

- 18 - 14:9 Zoom: This zooms up the wide picture (14:9 aspect ratio) to the upper and lower limits of the screen. Panoramic: This stretches the left and right sides of a normal picture (4:3 aspect ratio) to fill the screen, without making the picture appear unnatural. The top and bottom of the pictu...

- 20 - Connect Peripheral Equipment There is a wide range of audio and video equipment that can be connected to your TV.The following connection diagrams show you where the different (Optional) equipment should be connected at the rear side of the TV. High Definition Your Hitachi LCD Television is c...

- 23 - Tips Care Of The Screen Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer. Poor Picture Have you selected the correct TV system? Is your TV set or house aerial located too close to non-earthed audio equipment or neon...

- 24 - Specifications TV BROADCASTING PAL/SECAM B/G D/K K' I/I' L/L' RECEIVING CHANNELS VHF (BAND I/III) UHF (BAND U) HYPERBAND CABLE TV (S1-S20/ S21-S41) NUMBER OF PRESET CHANNELS 100 CHANNEL INDICATOR On Screen Display RF AERIAL INPUT 75 Ohm (unbalanced) OPERATING VOLTAGE 220-240V AC, 50 Hz. AUDIO...

- 25 - Appendix A: PC Input Typical Display Modes The display has a maximum resolution of 1366x 768, vertical sync. frequency range of 56-85 Hz and a horizontal sync. frequency range of 30-69 KHz.The following table is an illustration of some of the typical video display modes. + RUL]RQWDO 9HUWLFDO ...

- 26 - Appendix B: DVD Player Selection You can use this remote control to operate the selected brand of DVD player by pressing the following buttons on the remote control simultaneously. %UDQGVRI'9'3OD\HU 3UHVV %UDQGVRI'9'3OD\HU 3UHVV +LWDFKL 5&$ 3LRQHHU 0LWVXELVKL 3DQDVRQLF 2QN\R 7RVKLED =HQLW...

- 28 - UK Guarantee Your Guarantee of Excellence Thank you for purchasing this Hitachi Television. In the unlikely event that this product should develop a fault, we undertake to replace or repair any part of the product which fails due to a manufacturing defect within 12 months of the date of purch...

TV/AV MENU P/CH VOLUME Rear view ANT.IN VCR AV-1 AV-2 QUICK GUIDE QUICK GUIDE QUICK GUIDE IMPORTANT - If placing TV into cabinet or alcove, ensure there is at least a 100mm (10cm) gap to the sides, rear and top of the TV. This is to allow for adequate ventilation during operation. Please read the ma...

basic functions of remote control connect the TV plug to the mains socket switch your TV onby pressing the On/Off button NB: When the set is first switched on, the set will be in standby . Press the channel up down (P- and the indicator on the front of the set will illuminate red , P+) or numeric bu...

Once the TV has found all your local stations, they are then automatically assigned a programme numberand name, if available from the broadcast. If you would like to change the programme number or order, please refer to the Program Menu section of the instruction book. important note before starting...

- 33 - *% Installation Of The TFT TV To The Wall 1- To install the TFT TV on the wall, first of all, foot assembly should be removed. (Figure 1). Unscrew the 4 screws (M3 x 6) that attach the foot assembly to the TFT panel and remove the foot assembly from the TFT panel. 2- Place the 4 plastic pins ...