Page 2 - Table of Contents
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 2 Table of Contents 1. IMPORTANT SAFETY INSTRUCTIONS ................................................................................................................. 3 2. General Information ....................................................................
Page 3 - MPORTA; WARN; ANT SAFE; NING; ETY INST
1. I Si MPORTA WAR Failure to f WARN Suction in sucti njury and/or de Hair EntraLimb Entracracked, mBody SuctEvisceratisump or sudisemboweMechanicopening of WARN o Wbeap o D o D o Th o N o Re o Ingu o In WARN suction ou WARN material ca WARN replaced a CAUT being usedon this propositioned WARN start...
Page 4 - SAVE THESE INSTRUCTIONS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 4 WARNING – Risk of Electric Shock. All electrical wiring MUST be in conformance with applicable local codes, regulations, and the National Electric Code (NEC). Hazardous voltage can shock, burn, and cause death or serious property damage. To reduce the ris...
Page 5 - General Information; Installation and Wiring; Fire and burn hazard.; HP
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 5 2. General Information 2.1. Introduction This manual contains information for the proper installation and operation of the Hayward MaxFlo XL Series. The instructions in this manual MUST be followed precisely. Failure to install according to defined instru...
Page 6 - MAXIMUM RECOMMENDED SYSTEM FLOW RATE BY PIPE SIZE
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 6 3.2. Pump Mounting Install pump on a level concrete slab or other rigid base to meet all local and national codes. Secure pump to base with screws or bolts to further reduce vibration and stress on pipe or hose joints. The base must be level, rigid, and v...
Page 7 - Risk of dangerous or fatal electrical shock
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 7 3.6. Electrical Specs Use copper conductors only. For indoor & outdoor use. PUMP MODEL TOTAL HP RATED HP VOLTAGE AMPS SP2305X7 0.95 0.75 115 / 208-230 10.0 / 6.0-5.0 SP2305X7EE 0.95 0.75 115 / 208-230 9.2 / 4.7-4.6 SP2305X7EESP 0.95 0.75 115 / 208-230...
Page 8 - To Wire a Dual-Voltage Motor; WARNING; To Wire a Two-Speed Motor
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 8 To Wire a Dual-Voltage Motor Dual voltage motors have a plug to change from 230 volts (factory setting) to 115 volts. 1. Turn off power. 2. Remove the motor end cover. 3. If you have 230 volts motor supply voltage, confirm that the plug is set for 230 vol...
Page 9 - Separation Hazard; Maintenance
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 9 WARNING – If circulation equipment must remain in the plumbing system during water pressure test, do not apply more than 10 psi pressure to the system. Be sure water pressure has been released, using the filter manual air relief valve, before removing pum...
Page 10 - Shaft Seal Change Instructions
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 10 CAUTION – Use ONLY propylene glycol as antifreeze in your pool/spa system. Propylene glycol is non- toxic and will not damage plastic system components; other anti-freezes are highly toxic and may damage plastic components in the system. Drain all water ...
Page 11 - Seal Installation
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 11 7.4. Seal Installation 8. Clean and lightly lubricate the motor shaft and seal recess in the seal plate (item #13) with a dilute solution of non-granulated liquid-type soap. Gently wipe the polished surface of the ceramic seal with a clean, soft, cotton ...
Page 12 - Replacing the Impeller and Diffuser; Replacing the Motor Assembly
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 12 7.5. Replacing the Impeller and Diffuser 11. Screw the impeller (item#10) onto the motor shaft in a clockwise direction. Tighten snugly by holding motor shaft with wrench as noted in step #4. 12. Place the diffuser (item #9) over the impeller (item#10) o...
Page 13 - Replacement Parts; Parts Diagram
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 13 8. Replacement Parts 8.1. Parts Diagram Figure 8.1-1 8.2. Parts Listing Ref. No. Part No. Description Qty. 1A SPX2300DLS Strainer Cover Kit (Includes Strainer Cover, Lock-Ring, O-Ring) 1 1B SPX2300DLSB Strainer Cover Kit for Biguanide Sanitizers (Include...
Page 14 - Troubleshooting; General Problems
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 14 Ref. No. Part No. Description Qty. MOTORS SPX2705Z1M Motor, ¾ HP, Threaded Shaft (Single Phase, 60 Cycle 115V/208-230V) 1 SPX2705Z1ME Motor, ¾ HP, Energy Eff. Threaded Shaft (Single Phase, 60 Cycle 115/208-230V) 1 SPX2707Z1M Motor, 1 HP, Threaded Shaft (...
Page 15 - Warranty; HAYWARD
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 15 • Low Flow – Generally: 1. Clogged or restricted strainer or suction line. Clean skimmer strainer basket and/or pump strainer basket. Contact a qualified repair professional. 2. Undersized pool piping. Correct the piping size. 3. Plugged or restricted di...
Page 16 - Product Registration; MaxFlo XLTM Pump
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 16 DATE OF INSTALLATION ____________________ INITIAL PRESSURE GAUGE READING (CLEAN FILTER) _______________________ PUMP MODEL __________________ 11. Product Registration *Retain this Warranty Certificate in a safe and convenient location for your records Pl...
