Hanover 9710002U - Manuals - manualsarea.com

Page 3 - HARDWARE CONTENTS; NN; SAFETY INFORMATION; D NGER

HARDWARE CONTENTS (shown actual size) EXTRA HARDWARE (PRE-ASSEMBLED) 3 AA II DD EE HH CC KK LL MM NN FF BB GG Reflector Spacer Qty. 3 Washer Qty. 9 Washer Qty. 9 ScrewQty. 9 Cap Nut Qty. 9 Screw Qty. 4 Bolt Qty. 4 Washer Qty. 4 Qty. Wrench Qty. JJ Qty. 3 Stainless Steel Bolt Qty. 4 BoltQty. 2 Nut Qt...

Page 6 - Hardware Used; CC; Bolts; Fill sand

6 ASSEMBLY INSTRUCTIONS Hardware Used AA BB Hardware Used CC 1 2 1. Line up holes on the bracket of wheel assembly (O) with the corresponding holes on base (M), then insert M8 x 16 mm bolts (BB) through holes. Tighten with M8 flange nuts (AA). Be sure the wheel assembly (O) is parallel to the base (...

Page 7 - EE; Reinforced Ring; OO; oo

7 ASSEMBLY INSTRUCTIONS Hardware Used 4. Secure post (J) to cylinder housing (H) using the reinforced ring (NN), M6 x 10 mm bolts (DD) and 5. side facing up. coupler (D). Thread the fastening nut (G) Loosen the fastening nut (G) to adjust the position of the EE NN x 4 x 1 Reinforced Ring OO x 1 DD M...

Page 8 - Reflector Spacer; LL; LL

8 ASSEMBLY INSTRUCTIONS 7. Attach reflector spacers (FF) and 8 large washers (GG) to the top of head assembly (C). Tighten the reflector spacers (FF). FF GG x 3 Reflector Spacer x 3 Hardware Used Hardware Used LL x 4 Stainless Steel Bolt assembly (C). Hardware Used LL x 4 Stainless Steel Bolt 9. Ins...

Page 10 - GG; large

10 ASSEMBLY INSTRUCTIONS Hardware Used GG KK 14 14. Screw gas hose (K) and regulator (L) onto propanecylinder (not included). Do not cross-thread.Place the propane cylinder into the cylinder housing (H), then close the door (I).The propane gas and cylinder are sold separately.Use a standard 20 lb. p...

Page 11 - ASSEMBLY INSTRUCTIONS; Fully close the tank valve by turning

11 ASSEMBLY INSTRUCTIONS Do not store a spare LP-gas cylinder under or near this appliance; Never fill the cylinder beyond 80 percent full; Place the dust cap on the cylinder valve outlet whenever the cylinder is notin use. Only install the type of dust cap on the cylinder valve that is provided wit...

Page 12 - OPERATION INSTRUCTIONS; Leak Check; WARNING

12 Regulator / Cylinder connection OPERATION INSTRUCTIONS Leak Check 1. Make 2-3 oz. leak check solution (one part liquid dishwashing detergent and three parts water).2. Apply several drops of solution where hose attaches to regulator.3. Apply several drops of solution where regulator connects to cy...

Page 13 - DANGER

13 OPERATION INSTRUCTIONS DANGER • CARBON MONOXIDE HAZARD• For outdoor use only. Never use inside house, or otherunventilated or enclosed areas. This heater consumes air(oxygen). Do not use in unventilated or enclosed areas toavoid endangering your life. Before Turning Gas Supply ON:1. Your heater w...

Page 14 - The burner may be noisy when initially turned on.; Normal; Figure 1

14 OPERATION INSTRUCTIONS If you experience any ignition problem please consult “Troubleshooting” on page 18. Caution: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of oils used in manufacturing will appear. Both smoke and odor will dissipate after approxi...

Page 15 - Operation Checklist

15 OPERATION INSTRUCTIONS Operation Checklist Shut Down: Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use. Note: After use, some discoloration of the emitter screen is normal. For a safe and pleasurable heating experience, perform this check before each use. Wh...

Page 16 - After Operation

16 OPERATION INSTRUCTIONS CARE AND MAINTENANCE After Operation 1. Gas control is in OFF position. 2. Gas tank valve is OFF. 3. Disconnect gas line. CAUTION: To avoid the patio heater tipping or falling over when the propane tank is empty or not installed, we recommend securing the unit to a solid, h...

Page 18 - TROUBLESHOOTING; PROBLEM

18 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Burner won’t light Burner flame is low Carbon build-up Thick black smoke Propane cylinder is frosted over Blockage in orifice Control knob is not in ON position Gas pressure is low Control knob fully ON Dirt or film on reflector and burner ...

Page 19 - ONE-YEAR LIMITED WARRANTY

19 ONE-YEAR LIMITED WARRANTY This product is inspected, tested and carefully packaged to minimize the chance of damageduring shipment. If a part within one year from the date of purchase proves to be defective in material or fabrication under normal use, the part will be repaired or replaced. The Co...

Page 20 - REPLACEMENT PARTS LIST; QUANTITY

REPLACEMENT PARTS LIST 20 N O I T P I R C S E D T R A P QUANTITY A Reflector Panel 3 B Reflector Plate 11 C Head Assembly 1 D H Post I Regulator JKL M N O Base Bucket (preassembled) Wheel Kit 1 E 1 F 1 Fastening Nut 1111111 1 Gas Hose Cylinder HousingDoor (preassembled) Screw CouplerTable Tightening...