Grundig 800 MILLENNIUM - Manuals

POWER SUPPLY AC ADAPTER Keep curtains and other flammable materials out of The SATELLIT 800 MILLENNIUM receiver is supplied direct contact with the AC ADAPTER to avoid overheat with an auto-switchable AC ADAPTER to power it ing. indoors. The AC ADAPTER is designed to be plugged into a wall outlet th...

POWER SUPPLY, cont'd. FIGURE 1: BATTERY INSTALLATION AND REMOVAL BATTERY SUPPLY: 9 VDC 6 X IEC-LR20 OR "D" CELLS DO NOT LEAVE BATTERIES IN UNIT FOR EXTENDED PERIODS. CHECK BATTERIES OFTEN. 9

INSTALLATION UNPACKING Carefully remove the SATELLIT 800 MILLENNIUM and included AC ADAPTER from the shipping carton and examine them for evidence of damage. If any damage is noted, immediately contact the transportation company responsible for delivery or return the unit to the dealer from whom it ...

FRONT PANEL DESCRIPTION 1. Pow er - Press this button to turn the unit on or off. 2. Headphone Jack - This connector accepts a 1/8" stereo/mono headphone connector. Stereo reception is possible only in the FM mode. All speaker outputs are automatically switched off when using the headphones. 3. ...

14 LCD DISPLAY DESCRIPTION 1. TIMER - This annunciator indicates the state of the Timer as either Active or Inactive. Refer to the 'CLOCK AND TIMER FUNCTIONS' section on page 21. 2. LOCK - When illuminated, this annunciator indicates that the Main 'TUNING' knob and all front panel keypads (except fo...

15 REAR PANEL DESCRIPTION 1. ANTENNA 1 - This connector is used when attaching receiving antennas with coaxial feed lines of 50 Ohm nominal impedance. It accepts a standard PL-259 plug. If selected by the 'Shortwave Antenna Select' switch (item 2), this input operates for the AM Broadcast and Shortw...

GETTING STARTED GENERAL OPERATING INFORMATION The SATELLIT 800 MILLENNIUM receiver has been designed for ease of use. Please take a few moments to read through this section and familiarize yourself with general operating information. MICROPROCESSOR RESET A power-up reset routine will be activated an...

17 GETTING STARTED, cont'd. SHORTWAVE 'METER' BAND DESIGNATOR ENTRY To facilitate tuning to particular sections of the shortwave band that contain many worldwide broadcasts of news, information and music, the SATELLIT 800 MILLENNIUM permits entry of the 'METER' band designator. In some cases, the wo...

18 GETTING STARTED, cont'd. The synchronous detector will lock to the strongest signal that is within the IF passband when it is activated. Most of the time, the strongest signal will be the carrier of the desired signal. First, be sure the main tuning is set to within 1 kHz of the desired station's...

19 MEMORY FUNCTIONS MEMORY DESCRIPTION The SATELLIT 800 MILLENNIUM contains 70 memory locations that can be used to store and recall commonly monitored frequencies. These 70 locations are divided into blocks of 10, ie. 00-09, 10-19 20-29, etc. This allows convenient grouping of frequencies. As an ex...

20 SCAN FUNCTIONS SCAN DESCRIPTION The SATELLIT 800 MILLENNIUM provides a time scan function of programmed memory channels using the button. Scan will begin and end within a 10 channel block of programmed memory channels as indicated by the most significant digit of the selected memory channel numbe...

21 CLOCK AND TIMER FUNCTIONS TIME DISPLAY The SATELLIT 800 MILLENNIUM incorporates a dual time clock allowing two 24 hour clocks to be set and maintained. During loss of AC power, or during battery changing, clock operation is maintained for a period of approximately 30 minutes, if the receiver has ...

CLOCK AND TIMER FUNCTIONS, 22 SETTING TIMER ON/OFF TIMES Press and hold the button for approximately 2 seconds until the 'TIMER' annunciator turns on, and 'ON' flashes. The 'ON' Time will also be indicated in the frequency portion of the display (same readout format as the clock) as well as the numb...

23 CLOCK AND TIMER FUNCTIONS, cont'd. Press Press 'CLR/LOCK' (enters no OFF Time for timer '1') Timers '1' and '2' Enabled Timer '1' Enabled: Timer '2' Disabled If either one or both the timer '1' or timer '2' are enabled, the TIMER symbol will continue to be displayed after the receiver is turned o...

2 5 SPECIAL USE FEATURES AND FUNCTIONS The SATELLIT 800 MILLENNIUM receiver has several special features that are referred to in the main body of this Owner's manual but may require additional explana-tion. LOCK ALL ENTRY TO KEYPAD The receiver front panel buttons with the exception of the button an...

26 QUICK REFERENCE GUIDE The s y m b o l indicates that the button is to be pressed within three seconds. Select normal frequency display (VFO) (page 13) Press 'VFO' Press 'BAND' Select Band (page 12) Press 'BAND' button (scrolls through Aircraft, FM Broad cast, Shortwave, and AM Broadcast bands). W...

29 GLOSSARY OF TERMS 1) AC I n p u t - Alternating Current power source available 12) HF - High Frequency band extends from at wall outlet sockets. approximately 1.5 MHz to 30 MHz. 2) AM - Signals in which the information is conveyed by 13) LCD - Liquid-Crystal Display - Low power consump amplitude ...

30 TROUBLESHOOTING PROBLEM PROBABLE CAUSE SOLUTION No front panel display or light. (A) Power connection. (B) Defective AC ADAPTER unit. (C) Batteries are discharged or not installed for portable operation, no AC power. (A) Check power supply cables. (B) Check AC ADAPTER. (C) Check/install batteries...