Grindmaster TEA-300 - Manuals

Page 3 - Warning Labels

American Metal Ware ® Tea Brewers Page 2 Warning Labels The following warning and caution statements are contained in different sections of this manual.Please read this manual and follow all safety precautions when operating or servicing thisequipment. ! WARNING: ELECTRIC SHOCK HAZARD ONLY QUALIFIED...

Page 4 - Electrical Requirements; WARNING: ELECTRIC SHOCK HAZARD

Set-Up / Position 1. Position the brewer on a strong, stable counter top or table. 2. Check the level front to back and side to side. Adjust the legs to the correct level. 3. See rough-in drawing in this manual for dimensions and locations of electrical and water input. Water Hook-Up IMPORTANT WATER...

Page 5 - Use Control Functions

Electrical Requirements (cont.) 3. The body of the brewer must be grounded. A ground lug is provided for this purpose. Initial Start-Up 1. Turn on the water supply to the brewer. Check for leaks at supply line to fill valve connection. 2. Make sure the power switch is turned to the “Off” position. T...

Page 6 - Operation; Timer Adjustment

American Metal Ware ® Tea Brewers Page 5 Operation 1. Place an empty tea dispenser on the base of the tea brewer. The placement should allow the bypass and the brew basket drain to empty into the container. 2. Remove the brew basket and line it with a paper filter . Paper size is 13" x 5" ( ...

Page 7 - Thermostat Adjustment; Cleaning Procedures; Cleaning After Each Brew

American Metal Ware ® Tea Brewers Page 6 Timer Adjustment (cont.) 3. This timer is adjustable from 15 seconds to 8 minutes. 4. Make the desired adjustments by turning the adjusting knob clockwise to increase timer setting; turning counter clockwise to reduce time. 5. Re-install top cover with screw ...

Page 8 - Service; To Drain Water Tank; WARNING: BURN HAZARD

Cleaning Procedures (cont.) Daily Cleaning Cabinet: The outside of the machine can be cleaned with a damp cloth, a household dusting spray or a stainless steel cleaner. Do not use an abrasive such as Scotchbrite or Brillo pads. These may mar the finish. Wipe the underside of the cabinet hood with a ...

Page 9 - To Remove the Water Tank Heating Element

To Remove the Water Tank Heating Element 1. Disconnect the power cord and remove the top cover . 2. Disconnect the wire leads to the heater and thermodisc . 3. Remove the spray head and the spray head nut . 4. Remove the tank cover after removing the (8) nuts securing the cover to the tank. Lift the...

Page 10 - TROUBLESHOOTING GUIDE; Remedy

American Metal Ware ® Tea Brewers Page 9 TROUBLESHOOTING GUIDE Problem/Cause Remedy Weak tea • Not enough tea used• Water not hot enough• Water not hot enough • Sprayhead clogged • Tea steeping time too short • Use 1 oz. (28 g) tea per 1 gallon (3.8 litre) finished product• Wait for Water Hot light ...

Page 14 - Tea-300 Wiring Schematic

American Metal Ware ® Tea Brewers Page 13 Tea-300 Wiring Schematic