Grindmaster PBIC-430V2E230 - Manuals

Grindmaster PBIC-430V2E230 – Manual in PDF format online.

Manuals:

Manual

Manual Grindmaster PBIC-430V2E230

Summary

Page 3 - Warning Labels; Located on front splash panel and lid of machine.; CAUTION

Warning Labels The following warning labels were on your dispenser when it was shipped from the factory. They should remain on your dispenserin good, readable condition at all times. If one of your labels is missing or damaged, order a replacement label immediately. Part # A546-445 Located on front ...

Page 4 - ELECTRIC SHOCK HAZARD!; ) Remove the brewer from the packing material and attach its legs.

Page 4 Shuttle Brewers & Airpot/Shuttle Brewers Installation WA R N I N G ELECTRIC SHOCK HAZARD! Installation of this appliance should be performed by qualified service personnel only. Improperinstallation could result in electrocution. Set-Up/Position 1) Remove the brewer from the packing mater...

Page 5 - NOT; WA R N I N G

Shuttle Brewers & Airpot/Shuttle Brewers Page 5 Installation (cont.) Electric Hook-up The brewer is designed to operate at the specified voltage on the nameplate with a tolerance of ± 10% for voltagedeviation. It is very important that the power line to the brewer be checked to make sure that th...

Page 6 - ) If ready lights are lit, press correct batch size button.; C A U T I O N; will make a subtle hissing sound while filling.

Page 6 Shuttle Brewers & Airpot/Shuttle Brewers  Operation C A U T I O N HOT LIQUID HAZARD! Water used for brewing coffee is very hot. Use caution when brewing, pouring, or transporting coffee. Accidental spills may result in severe burns. 1) Place an empty, warm Shuttle on the shelf, under the...

Page 7 - Adjustments; Temperature Adjustment; Approximate Boiling Point

Shuttle Brewers & Airpot/Shuttle Brewers Page 7 Adjustments All adjustments to machine are accessible through the front display(s). Refer to specifics below and theProgramming Routine section. All values are preset at the factory and may vary brewer to brewer. Temperature Adjustment Tank tempera...

Page 8 - During this routine, no pulsing or bypass will occur.; Control Features; Brew Countdown Timer:; will scroll; doneE; for 30 seconds then turn off.; Energy Savings Mode:; lower its holding temperature to 120°F. The display will scroll; SLEEPIng; brew portion on the Right side to the Left side.; Programming; To enter program mode:

Page 8 Shuttle Brewers & Airpot/Shuttle Brewers Adjustments (cont.) Brew Volume “br” Brew time can be set for each size visually. See Setting Brew Volume Procedure below.Brew time can also be adjusted through the display. See Programming Routine section. Setting Brew Volume Visually 1. Remove br...

Page 11 - Programming Sequence for Large Left Portion; Table 1

Shuttle Brewers & Airpot/Shuttle Brewers Page 11 Programming Sequence for Large Left Portion Table 1 PRE INFUSION PRE INFUSION TIME (OFF TO 2.00) TO PRESS-AND-HOLD UP & DOWN ARROWS FOR 5 SECONDS.DISPLAY WILL READ AS FOLLOWS: OG G O S S OR READING OR TO BREW TIME BYPASS RATIO LOW-TEMP/ LOW-TE...

Page 13 - Programming Sequence for Medium Portions; Table 2

Shuttle Brewers & Airpot/Shuttle Brewers Page 13 Programming Sequence for Medium Portions Table 2 PULSE OFF TIME (0:05-2:00) PULSE ON TIME (0:05-2:00) (OFF, 1 - 10) DISPLAY WILL READ AS FOLLOWS: TO PULSE BREW # OF PULSES PRESS-AND-HOLD UP & DOWN ARROWS FOR 5 SECONDS. TO ADJUST PULSE OFF BY-P...

Page 15 - Programming Sequence for Small Portions; Table 3

Shuttle Brewers & Airpot/Shuttle Brewers Page 15 Programming Sequence for Small Portions Table 3 PRESS-AND-HOLD UP & DOWN ARROWS FOR 5 SECONDS.DISPLAY WILL READ AS FOLLOWS: ADVANCE (OFF, 1 - 10) ADJUST READING OG G O S S (.05 TO 2.00) DISPLAY BREW TIME (.01 TO 6.00) BREW TIME PULSE OFF TIME ...

Page 16 - Urn cleaners that have been used successfully:

Page 16 Shuttle Brewers & Airpot/Shuttle Brewers Cleaning WA R N I N G Burn Hazard! Hot liquids and surfaces are present in this equipment. To avoid burns use caution when cleaning.Rinse hot parts with cold water before cleaning. Use gloves or a heavy cloth when removing hotparts from brewer. Af...

Page 17 - Service; common service tasks; Drain Water Tank; Remove Brew Valve

Shuttle Brewers & Airpot/Shuttle Brewers Page 17 Service The rest of this manual contains information to aid the service person who is working on this equipment. This pagehas information on performing common service tasks . Following this is the Troubleshooting section which can help diagnose pr...

Page 18 - Special Control Functions; User Lockout; 0 Pin Version; System Restore Function; Factory Specific Features; Factory/Field Test Menu

Page 18 Shuttle Brewers & Airpot/Shuttle Brewers Special Control Functions User Lockout User Lockout is achieved via the position of the LOCK jumper on the board header. Locate the header on the board(shown below) and place the jumper in the desired position. In the Locked position all menus in ...

Page 20 - Troubleshooting; Error Messages; Initial; Filling Problems

Page 20 Shuttle Brewers & Airpot/Shuttle Brewers Troubleshooting The following pages are provided to help determine the cause of problems with operation of the brewers and to indicate the appropriate solution for the problems. For each problem, the possible causes should be checked in the order ...

Page 21 - Problem; Tank does not refill; “No power to control

Shuttle Brewers & Airpot/Shuttle Brewers Page 21 Troubleshooting (cont.) Filling Problems Problem Possible Causes Service Check Remedy Tank does not refill • No electrical power to equipment • No water supplied to equipment • No power to control board • No power to control board and transformern...

Page 22 - Heating Problems; Tank does not heat

Page 22 Shuttle Brewers & Airpot/Shuttle Brewers Troubleshooting (cont.) Filling Problems Problem Possible Causes Service Check Remedy Tank does not refill • Fill valve or control board is faulty • Check to ensure proper connection between 6 pin connector and con-trol board. Check for proper con...

Page 24 - Brewing Problems

Page 24 Shuttle Brewers & Airpot/Shuttle Brewers Troubleshooting (cont.) Heating Problems Problem Possible Causes Service Check Remedy Tank does not heat • Contactor faulty. • Heater faulty. • Control board is faulty. • Ensure that coil on contactor is energizedby ensuring that there is proper v...

Page 25 - Note: Small variations from batch to batch are normal.

Shuttle Brewers & Airpot/Shuttle Brewers Page 25 Troubleshooting (cont.) Brewing Problems Problem Possible Causes Service Check Remedy Brew volume toolarge or too small • Sprayhead clogged. • Brew valves clogged with lime deposits. • Water supply pressure or flow rate not adequate. • Visually ch...

Page 26 - used on all PrecisionBrewTM V2.0 models

Page 26 Shuttle Brewers & Airpot/Shuttle Brewers Troubleshooting (cont.) Brewing Problems Problem Possible Causes Service Check Remedy Brew cycle willnot start • Controller faulty. • Check to see that the power is supplied to thecontroller by followinginstructions given in the Troubleshooting se...

Page 27 - Parts List for All Precision Brew Models

Shuttle Brewers & Airpot/Shuttle Brewers Page 27 ITEM DESCRIPTION PART # Reference Front View Picture: 1 Controller PB A530-066 2 Relay, Heater* A71450 3 Water Inlet Valve 24 VAC A725-117 4 Terminal Block A531-035 5 Spray Head APT400-105 6 Orifice Bypass A518-053 6A Retaining Pin for A518-053 A5...

Page 29 - Heater Model shown

Shuttle Brewers & Airpot/Shuttle Brewers Page 29 Top View (refer to key on page 27) 42 30 34 Tank Lid (refer to key on page 27) 3 Heater Model shown 50 52 51 50 36 35 38 35 32 36 52

Page 30 - Shuttle Parts List

Page 30 Shuttle Brewers & Airpot/Shuttle Brewers ITEM DESCRIPTION PART # 1 Faucet Model ES A537-053 2 Shank w/ Chrome Bonnet A522078 3 Gauge Assembly A718-018 4 Kit, Shuttle Lid A725-092 S.S. Shuttle Cover(not shown)* A713-027 5 Lid Retaining Clip A548-142 6 Lid Stopper w/ O-Ring A548-140A61365 ...

Page 31 - VS

Shuttle Brewers & Airpot/Shuttle Brewers Page 31 VS- 1.5S VS -S 3 1 8 5 2 9 6 7 4 5 1 4 6 2 3 7 8 ITE M NO . Tit le PART NU M BE R V S-1 .5 S/Q TY. 1 Sta n d Bo d y A548-157 1 2 Tra y fo r Sta n d A 548-159 1 3 V ac uum S h uttl e V S- 1. 5 1 4 Sta n d Ba se A548-158 1 5 Tra y T o p A 517-018 1 ...

Page 32 - solution for cleaning.; ) Cleaning the Faucet assembly and silicone tube:; Cleaning & Sanitizing Instructions

Page 32 Shuttle Brewers & Airpot/Shuttle Brewers These cleaning and sanitizing instructions are only a guideline to be used for the cleaning and sanitizing of the VS-1.5S and VS-S with VS-1.5. In-house cleaning and sanitizing methods may be more effective. Grindmasterassumes no responsibility fo...

Page 33 - Wiring Diagram - Precision Brew 430 Series

Shuttle Brewers & Airpot/Shuttle Brewers Page 33 Wiring Diagram - Precision Brew 430 Series Models APB-430V2, APBVSA-430V2, and APBIC-430V2

Page 34 - Wiring Diagram - Precision Brew 330 Series

Page 34 Shuttle Brewers & Airpot/Shuttle Brewers Wiring Diagram - Precision Brew 330 Series Models APB-330V2, APBVSA-330V2, and APBIC-330V2

Page 35 - Wiring Diagram

Shuttle Brewers & Airpot/Shuttle Brewers Page 35 Wiring Diagram APB-430V2E230, APBVSA-430V2E230, APBIC-430V2E230 (Single or Three Phase Models)

Page 43 - Control Board; all PrecisionBrewTM V2.0 models

Shuttle Brewers & Airpot/Shuttle Brewers Page 43 Control Board all PrecisionBrew™ V2.0 models Refers to software version number. Subject to change.

Grindmaster Manuals

Grindmaster AT-AP Manual
Grindmaster 3312 Manual
Grindmaster B-ID Manual
Grindmaster 250AB Manual
Grindmaster C-3D Manual
Grindmaster 250RH-3 Manual
Grindmaster JX28AC Manual
Grindmaster D15 Manual
Grindmaster 830 Manual
Grindmaster 115A Manual
Grindmaster 10HE Manual
Grindmaster D25 Double Bowl Manual
Grindmaster 11HE Manual
Grindmaster 3342 Manual
Grindmaster AT-3WR/AT-3WRE Manual
Grindmaster 875 Manual
Grindmaster AT-TC/AT-TCE Manual
Grindmaster C-2S Manual
Grindmaster PM4-B Manual
Grindmaster 74410 Manual