Glem Gas ML96MVI3 - Manuals

5 SAFETY CHAIN AND ANTI TILT BRACKETS The upright cookers have a safety chain to prevent damage to the gas pipes if the upright cooker is moved and anti tilt brackets to prevent accidental tipping of the cooker. Safety chain The chain must be secured to the wall behind the upright cooker by fitting ...

6 INSTALLATION OF ANTI TILT BRACKET Install the legs to the cooker and adjust the height to the desired level. Make sure that this height is absolutely correct to what you require. On the rear of the cooker there is a covering panel. Accurately measure the distance from the top of this panel to the ...

7 IMPORTANT INFORMATION AND WARNINGS BEFORE USING THE COOKER After the cooker is unpacked make sure that it is not damaged. If unsure please contact Glem Gas Australasia on 1 300 307 917. All packaging materials should be disposed of appropriately. Cookers are hot . This cooker meets Australia Stand...

8 REMOVING THE OVEN DOOR AL, EI, EB and EM series 1. Open the oven door completely. 1. With the aid of a small screwdriver flick up the hinge lock A on each hinge and swing it into the slot. 1. Take the weight of the door and slowly partially close it until there is a certain resistance. At this poi...

9 MA/IT/DI/ML SERIES DOOR REMOVAL AND RE INSTALLATION The DI and ML series of Glem and Emilia cookers have the latest oven door hinge design technology from Glem Gas. For the removal and re-installation of the oven door with the new hinges please follow these procedures. TO RE-INSTALL THE DOOR IMPOR...

10 1 2 3 4 5 6 SEQUENZA VETRO ESTRAIBILE: IMPORTANTE: Al termine del montaggio del vetro interno verificare che nell'angolo in basso a destra fig.(4-6) sia presente la scritta VIT. CLICK AND SLIDE INNER GLASS REMOVAL - SOME MODELS IMPORTANT: Ensure that the bottom right corner of the inner glass rea...

11 OPERATION OF GAS HOB GAS BURNERS The combination of high-speed burners with those of a standard type allows all types of cooking to be achieved. Burners Locations 53 - 60cm wide models 80 - 90cm wide models Left back Left front Right front Right back Auto Flame Ignition - Some models To ignite an...

12 ELECTRIC COOK TOP SOLID HOTPLATES The solid cast hotplates are sealed all around which means that spilt liquids cannot penetrate under the hotplates. Rotate the knob to the position required for the needs of the cooking; the higher the number, the higher the heat. The plates marked with a central...

13 OPERATING THE GAS OVEN The oven is equipped with a gas thermostat. Its purpose is to keep the temperature as a constant heat. The oven is fitted with electronic spark ignition and a safety shut off device. Lighting the Oven First open the oven door and remove the grill tray. Leave the grill tray ...

14 Oven Preheating After the oven has been switched on, keep the door open for a minute then close the door gently so there is no risk of extinguishing the flame. Set the oven knob to the required temperature and wait for about 20 minutes before introducing the food. Comply with the cooking indicati...

15 OPERATING THE ELECTRIC OVEN Multifunction Electric Oven - some models Remove grill tray. Choose a function using the selector knob. Turn it to the symbol of the cooking function you wish to use. Then rotate the thermostat knob to the desired temperature. Wait until the thermostat indicator light ...

16 Cakes Static Fan oven Static Fan oven Chocolate Cake 2 2 3 180 - 190 180 35 - 40 Cream Caramel 3 2 3 130 - 150 130 30 - 35 Cup Cakes 1 1 2 190 - 200 180 - 190 18 - 20 (35 cakes) Fruit Cake 3 2 3 175 - 190 165 - 180 35 - 45 Jam Tarts 2 2 3 185 - 200 185 - 200 40 - 50 Nut Cake 3 2 3 190 - 200 180 -...

18 BAKING TROUBLE SHOOTING Problem Cause Solution Cooking unevenly Wrong location in oven Use shelf to place food in centre of oven Wrong size tray Try alternatives Heat variations in oven Turn food whole cooking Burning on top Oven not preheated Turn oven on and wait for light to go off before plac...

19 OPERATION OF THE 3 BUTTON TIMER Setting the clock When the oven is first connected, or after a power failure, ‘0.00’ will flash on the display.To set the clock, push the TIMER ON/OFF button, then the (+) or (–) buttons immediately. The time of day will be saved after 10 seconds. Using the timer T...

22 PROGRAMMING EXAMPLE: I wish to use fan forced setting at 180 degrees to cook for 45 minutes including heat up and to finish cooking at 12.30 in time for lunch. 1. Press MENU and hold then press again - “DUR” displays. 2. Press + to 45 minutes 3. Press MENU once – “END” displays 4. Press + to 12.3...

23 CLEANING AND MAINTENANCE WARNING: the oven and hob must be kept clean, as a build up of fat constitutes of a fire risk 1. Cleaning of Stainless Steel: In order that your cooker retains its new appearance, care should be taken to protect the stainless steel finish. Never use gritty or abrasive spo...

24 7. Grill Element/Top Element - All models: This element must never be sprayed with any detergents. A damp cloth and a bottlebrush can be used to clean the roof of the oven and the element itself. Never soak the element and always dry it after cleaning as not doing so can lead to deterioration. It...

25 Minimum Clearances When the upright cooker is installed abutting a side or rear wall, the wall must be of non-combustible material, eg ceramic tiles. The following minimum clearances to combustible materials must be observed: • Minimum clearance from hotplate to side wall must be 200 mm. • Minimu...

28 INSTALLATION - ELECTRICAL CONNECTION Before connecting the plug into the power socket, follow these instructions: • The electrical supply for the upright cooker must be a 240 Volt 50 Hz. • The fuse and electrical wiring of the dwelling must support the load of the appliance. • The 3-pin plug, use...

29 The fixed consumer piping outlet should be at approximately the same height as the cooker connection point, pointing downwards and approximately 150mm to the side of the cooker. The hose should be clear of the floor when the cooker is in the installed position. Ensure that the safety chain is ins...

30 GAS CHECKS AND ADJUSTMENTS - AIR SETTING Oven burner Check the aeration setting of the oven burner and if necessary adjust by following these procedures. Remove the shelves and vitreous enamelled floor (taking care not to damage the finishes). To remove the oven floor it may be necessary to remov...

31 FINAL CHECK Operate all cooker burners on high and low flames and check that each burner ignites properly and has a stable flame. The following may be considered to be abnormal: • If the burners have yellow tipping. • If the pots are sooting up underneath. • If the burners are extinguished by ope...

33 PRODUCT WARRANTY Thank you for choosing a Glem Gas Appliance, the purchase of this appliance is an important investment in your home and so to protect your investment we urge you to complete the registration card attached, please return it immediately. The benefits conferred by this warranty are ...

34 h) If you live outside the service area of the Glem Gas Australasia service agents this warranty does not cover the cost of transport of the appliance for service or the service agent’s travelling time. 3. This warranty does not cover any glass damage or replacement of light bulbs. 4. Glem Gas Au...

35 INSTALLER’S CHECK LIST You must test the cooker after installation before you hand it over to the customer. You must have a manometer and a connecting tube.The following checks have to be made to commission the cooker and to activate the warranty: INSTALLATION CHECK Have the supplied blue washers...