Genie 3630436275- Manuals

Page 2 - See Power Head Assembly Exploded View on page 15; IT IS CRITICAL THAT ALL SAFETY WARNINGS; eNie; Service From Authorized Dealers; What this warranty does not cover:; SAVE THESE INSTRUCTIONS; Visit Our Website at:; Please note the following information,so it is available if you; NOTE; Please keep original or photocopy of your sales receipt

2 For Help, call 1-800-35-GENIE or visit www.geniecompany.com * Model Number and Serial Number are located on Motor Cover inside the lens . See Power Head Assembly Exploded View on page 15 IT IS CRITICAL THAT ALL SAFETY WARNINGS MARKED CLEARLY IN BOTH THE MANUAL AND POSTER ARE READ, UNDERSTOOD AND F...

Page 3 - oVeRView of poteNtial haZaRDS; MOVING DOOR; IMPORTANT INSTALLATION; afety

For Help, call 1-800-35-GENIE or visit www.geniecompany.com 3 oVeRView of poteNtial haZaRDS Overhead doors are large, heavy objects that move with the help of springs under high tension and electric motors . Since moving objects, springs under tension, and electric motors can cause injuries, your sa...

Page 4 - Re; Tools used in this section:

4 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Figure 1 Note Door Type SECTIONAL DOOR, TORSION SPRINGS SECTIONAL DOOR, EXTENSION SPRINGS ONE-PIECE DOOR, TRACKLESS m eaSuRe G aRaGe D ooR h eiGht A Measure door height (floor to top of door) using a tape measure .B This new Garage Door O...

Page 6 - Figure 8 Recommended Tools; TO REDUCE THE RISK OF; IMPORTANT; Always keep the moving door in sight and away from people and; SAVE THESE INSTRUCTIONS.

6 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Figure 8 Recommended Tools Go to Assembly and Installation Poster for full Installation Instructions. R eCommeNDeD toolS A Tools (Figure 8):B Additional tools to make installation easier: • Slotted and phillips screw-driver bits • Stud fi...

Page 7 - A Pre-set Force Controls to midpoint between Hi and LO; WARNING; Every 10 minutes you wait restores 5 cycles; aiNteNaNCe; Figure A-2 Setting Limit Switches

7 For Help, call 1-800-35-GENIE or visit www.geniecompany.com a DjuStiNG l imit S witCheS aND f oRCe C oNtRolS Adjustment 1: A Pre-set Force Controls to midpoint between Hi and LO (Figure A-1) . B Adjust the Close Limit Switch: (Figure A-2) . • Press Wall Console to close garage door . – If door doe...

Page 8 - Figure A-3 Checking Contact Reverse; CCeSSoRieS

8 For Help, call 1-800-35-GENIE or visit www.geniecompany.com NOTE The door must contact the 2” x 4” board before the Carriage activates the Close Limit Switch . If not, readjust the Close Limit Switch . S ettiNG C oNtaCt R eVeRSe f uNCtioN Adjustment 2: NOTE Limit Switch and Force Adjustments must ...

Page 9 - To Erase All Remotes from Power Head Memory; NStall; Use the Wall Console included with Opener . Any other

9 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Learn Code Button Figure MA-2 Learn Code Button and Indicator Light A Install two 60 Watt light bulbs (not included) into Light Sockets (Figure MA-4): • Rough service, 130 Volt bulbs are recommended . B Install Lens into slots in Motor Co...

Page 10 - MAINTENANCE; RoubleShootiNG; Possible Problem

10 For Help, call 1-800-35-GENIE or visit www.geniecompany.com A Monthly: • Door springs and door hardware: – Oil door roller, bearings, and hinges using silicone lubricant or light oil . • Balance Door . – Close door . – Release Magnetic Carriage Assembly from Rail Assembly by pulling down on Emerg...

Page 11 - until door is fully closed .

11 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Opener System Self-Diagnostic Troubleshooting• See Status Light on Figure MA-2, page 9) You See Problem What to Do Reference 1 BLINK, Motor Drive • Reset Opener—unplug (or disconnect power), wait 5 seconds, plug Pause Board back in (reap...

Page 12 - General Troubleshooting (Always Check the Status LED Light); Problem

12 For Help, call 1-800-35-GENIE or visit www.geniecompany.com General Troubleshooting (Always Check the Status LED Light) Problem What To Do Opener does not run 1 . Check power source . from Remote Control A . If Opener is connected to an outlet : • Plug a working lamp into outlet used for Power He...

Page 13 - Opening Cover May Result in Electric Shock; iRiNG

13 For Help, call 1-800-35-GENIE or visit www.geniecompany.com General Troubleshooting (Always Check the Status LED Light)(Continued) Problem What To Do Remote Control has less • Relocate Remote Control inside car . than 25’ operating range • Ensure Remote Control is pointing toward garage door when...

Page 14 - Denotes items not shown on page 15 . These items will be illustrated; Parts List; oweR; POWER HEAD ASSEMBLY PARTS LIST

14 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Item Part Name Quantity Item Part Name Required 1 Power Head Assembly (main carton) 1 2 1/4”-20 x 13/16” Hex Head Shoulder Bolt (blue bag) 2 (yellow shoulder bolt) 4 Rail Assembly, 3 piece (main carton) 1 4A First Rail Section (main cart...

Page 16 - STB

16 For Help, call 1-800-35-GENIE or visit www.geniecompany.com ® No C .O .D . shipments . Please include check or money order, made payable to The Genie Company . Do not send cash . Allow 3-4 weeks for delivery . 1-800-354-3643 . Please have part number and credit card ready . Mail Order Form to: Ge...

Manuals:

User Manual Genie 3630436275

Summary

Genie Manuals