Page 2 - INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS; For any queries or assistance call; Customer Service; Australia Only; IMPORTANT SAFETY RULES
2 INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS Prior to assembling your appliance, the following must be reviewed. Compliance with the following should result in satisfactory heater operation. This instruction manual should be retained for future reference. The installation must conform wi...
Page 3 - POL CYLINDER CONNECTION DEVICE
3 Screw the coupling nut of regulator into the cylinder valve outlet. (Cylinder not included) POL CYLINDER CONNECTION DEVICE Type of Gas Propane Consumption 33 MJ/h Operating Pressure 2.75 kPa Injector Size 1.6 mm Heater specifications can be found on the data label. d. The flame should be visually ...
Page 4 - PARTS LIST
4 PARTS LIST 1. Middle Plate 1pc 2. Control Box 1pc 3. Bottom Panel 1pc 4. Lower Support Leg 4pcs 80cm Long Rubber Foot 5. Upper Support Post 4pcs 6. Upper Plate 1pc 7. Lower Plate 1pc Pre-assembled in Middle Plate 8. Glass Tube 1pc 9. Radiant Head 1pc Pre-assembled in Upper Plate 10. Reflector 1pc ...
Page 5 - ASSEMBLY INSTRUCTIONS
5 ASSEMBLY INSTRUCTIONS Note: Remove any transit protection material.Tools required: Phillips head screw driver and 2 adjustable spanners. STEP 1The lower support leg has a rubber foot at the bottom. Remove the five screws from each leg, using them to attach the bottom panel and middle plate from th...
Page 9 - OUTDOOR FLAME HEATER - FOR OUTDOOR USE ONLY; Minimum Clearance from Combustible Surfaces*:
9 OUTDOOR FLAME HEATER - FOR OUTDOOR USE ONLY Minimum Clearance from Combustible Surfaces*: *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned. 1950mm 800mm Hose c onnec tion poin t 700mm 650mm 500...
Page 10 - OPERATION; LIGHTING INSTRUCTIONS; WARNING
10 OPERATION LIGHTING INSTRUCTIONS STEP 1 Ensure that the control knob is OFF. Slowly open the gas cylinder valve. STEP 2 Press and turn the control knob to LIGHT position, push the igniter to generate spark while keeping control knob pressed in. STEP 3 Check for the pilot flame through glass tube. ...
Page 11 - TROUBLE SHOOTING
11 Problem Possible Causes Solution Main burner will not light Gas valve may be OFF Turn the gas valve ON LPG cylinder empty Refill LPG cylinder Orifice blocked Clean or replace orifice Air in supply system Purge air from lines Loose connection Check all fittings Pilot will not stay on Debris around...
Page 12 - SAFE APPLIANCE LOCATIONS
12 This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection.Any enclosure in which the appliance is used shall comply with one of the fol...
